Maytag MAT12PDS, MAT12PSB, MAT12PRB Touch pad, Cycle Selector Switch, Transformer, Motor Run Relay

Page 17

Disassembly Procedures

!WARNING

Touch pad

1.Disconnect power supply to unit.

2.Remove all four T-20H Torx screws securing control panel facia.

3.Remove Control Panel.

4.Remove Control Board.

5.Remove two Pozi-drive screws securing touch pad to Control panel.

Cycle Selector Switch

1.Disconnect power supply to unit.

2.Remove all four T-20H Torx screws securing control panel facia.

3.Pull selector switch knob off switch shaft.

4.Remove two screws holding switch to control panel.

To avoid risk of electrical shock, personal injury or death; disconnect power to unit before servicing.

5.Lay control panel forward.

6.Remove wires from switch (note switch position) and remove switch.

Note: When replacing switch, note the position of “top” on the switch.

Transformer

1.Disconnect power supply to unit.

2.Remove Control Panel.

3.Remove two screws securing transformer and disconnect wire harness.

Motor Run Relay

1.Disconnect power supply to unit.

2.Remove Control Panel.

3.Disconnect wires from Motor Relay.

4.Remove screw securing relay to Control Panel.

©2003 Maytag Appliances Company

16022842 Rev. 0

17

Image 17

Contents Service Important Information Recognize Safety Symbols, Words, and LabelsTable of Contents Important Safety Information About Ground Wires Electrical Service InformationRelated Publications Proper Grounding and Polarization of 120 Volts Wall OutletsExplanation Grounding InstructionsParts and Accessories ServiceGeneral Information Model IdentificationHOW IT Works Water Level Control Pressure SwitchFill Water Valve Non-ThermostaticTransmission Drive MotorHelical Drive Spin cycle completedPart Number Description Tools for ServicingMechanical Troubleshooting Troubleshooting ProceduresDamper Pad Noise Drive Lug AdjustmentPump Belt Adjustment Electrical Troubleshooting Motor Testing Component TestingAgitation Spin Windings Wiring Harness Connections ReadingsCS Coin Slide Model Timer MN Manual Model TimerControl Panel Control Board MicroprocessorTouch pad Cycle Selector SwitchTransformer Motor Run RelayIndicator Light Timer models Lid Switch Assembly After seriesLid Switch Assembly Prior series Reversing Motor RelayUnbalance Lever and Plunger Assembly Pressure SwitchReinstalling Lid Switch Air DomeCoin Slide Water ValveCoin Drop Acceptor Meter CaseCoin Vault Switch Service Door SwitchReinstalling the Lid Coin SensorFront Panel Tub CoverBalance Ring Top CoverAgitator Access PlugInner Tub Tub CenteringMounting Stem Reinstalling Mounting StemOuter Tub Tub BearingTransmission Reinstalling tub bearingLip Seal Reinstalling Lip SealBrake Package and Radial Bearing Damper AssemblyBelts Drive Pulley and Rotor BearingDrive Motor and Motor Base Pump