Maytag MAT12PSA, MAT12PSB manual Reversing Motor Relay, Lid Switch Assembly After series, Lift Tab

Page 18

Disassembly Procedures

!WARNING

Reversing Motor Relay

1.Disconnection power supply to unit.

2.Remove all four T-20H Torx screws securing control panel facia.

3.Disconnect all wires attached to Reversing Motor Relay.

4.Remove single screw securing relay.

Note: Notice the positioning tab for ease in mounting and locating relay onto the Control Panel.

To avoid risk of electrical shock, personal injury or death; disconnect power to unit before servicing.

Lid Switch Assembly (After series 15)

1. Disconnect power supply to unit.

2. Remove Control Panel

3. Remove wire connector attached to the switch.

Indicator Light (Timer models)

1.Disconnect power supply to unit.

2.Remove Control Panel.

3.Compress tab on the end of the Indicator Light and remove from back side of Control Panel.

4.Remove wires from assembly.

4. Lift tab and move switch forward and out.

Lift Tab

Lid Switch Assembly (Prior series 15)

1.Disconnect power supply to unit.

2.Remove Control Panel.

3.Remove wires attached to switches and fuse.

4.Remove adjusting screw securing lid switch bracket to the top cover.

18

16022842 Rev. 0

©2003 Maytag Appliances Company

Image 18

Contents Service Recognize Safety Symbols, Words, and Labels Important InformationTable of Contents Important Safety Information Related Publications Electrical Service InformationAbout Ground Wires Proper Grounding and Polarization of 120 Volts Wall OutletsGrounding Instructions ExplanationGeneral Information ServiceParts and Accessories Model IdentificationFill Water Level Control Pressure SwitchHOW IT Works Water Valve Non-ThermostaticHelical Drive Drive MotorTransmission Spin cycle completedTools for Servicing Part Number DescriptionTroubleshooting Procedures Mechanical TroubleshootingDrive Lug Adjustment Pump Belt AdjustmentDamper Pad Noise Electrical Troubleshooting Component Testing Motor TestingWindings Wiring Harness Connections Readings Agitation SpinControl Panel MN Manual Model TimerCS Coin Slide Model Timer Control Board MicroprocessorTransformer Cycle Selector SwitchTouch pad Motor Run RelayLid Switch Assembly Prior series Lid Switch Assembly After seriesIndicator Light Timer models Reversing Motor RelayReinstalling Lid Switch Pressure SwitchUnbalance Lever and Plunger Assembly Air DomeCoin Drop Acceptor Water ValveCoin Slide Meter CaseReinstalling the Lid Service Door SwitchCoin Vault Switch Coin SensorBalance Ring Tub CoverFront Panel Top CoverInner Tub Access PlugAgitator Tub CenteringOuter Tub Reinstalling Mounting StemMounting Stem Tub BearingReinstalling tub bearing TransmissionReinstalling Lip Seal Lip SealDamper Assembly Brake Package and Radial BearingDrive Pulley and Rotor Bearing BeltsPump Drive Motor and Motor Base