Installation and adjustment

Start

Pause

the washing will finish about 18 hours later

Water level

Please install and adjust the machine according to the requirement of the mannual. It is very important to your security and correct operating the machine.

The soak procedure can work in cooperation with automatic programs like standard, carpeting fiber.There is intermittent pulsator stirring during soak.

After the machine starts operation, you can only set the program and procedure during washing,

Install the inner cover

1.Open the top lid of the washing machine.

2.Put the inner cover component on the outer tub cover, aiming the inner cover shaft to the installation hole of the corresponding outer tub cover shaft groove.

3.Firstly insert the inner cover shaft of one side into the corresponding outer tub cover shaft groove, then push the another inner cover shaft into the corresponding outer tub cover shaft groove. Please install to designated position to guarantee there are no dropping or abnormal sound in opening and closing of the inner cover, and the operation shall be smooth. Do not dismount the inner cover component after washing.

Outer tube cover

Outer tube cover shaft groove

Inner cover shaft

Damping cushion

Inner cover components

Section • enlarging

Push

and can not make setting in other cases.

The function of	Softener	will be chosen at the same time as sterilize is selected ,when the
sterilize is not chosen		,there will be no water flowing into the box for thesoftener preparation.

So do not add softener preparation into the box to aviod wasting

If the water pressure is too low,in order to wash the closes cleanly,the machine will change from " saving water "to "storing water "automatically.

4 Push the " water level "button,select suitable water level

After switching on the power, the washing machine will execute fuzzy program automatically to detect the cloth. After defection, it can set the water level automatically. To select other water level, first push the "start/pause" button, then push the "water level" button to set the water level.

Air-dry

5. Push the "Air-dry "button,select Air-dry

Install the bottom plate

After you open the package, please lean the washing machine gently down on soft items ( like the towel cloth, blanket, etc. ). Install the bottom plate to the bottom of the machine, then lift the machine up gently. See to the figure:

Back

Front

Soft items

Bottom plate

Air-drying could reduce time drying in the sun; fibre could be dress on after ironing

6 Push the "reserve" button to select suitable	Reserve
reserve wash program

After switching on the power, the reserve program is set to off mode automatically. If you need to set the washingprocedure to be finished at reserved time, please push the " reserve " button to set the reserve wash program. Refer to reserve button in Page 11 for selection.

Confirm the operation of reserve program

Adjust the Installation position

The distance that washing machine away from wall should be above 20mm. The largest allowed slope of the shank base of the machine is 2 . The slanting or rough ground will result in unstable running or stoppage of the machine. Please adjust it with following methods:

When the "reserve" function is activated, the indicator light of the program you have set will be off. The "reserve (hour)" and "time remain" indicator lights will be on. During reserve procedure, push the "reserve" button to display the reserve mode.

To change the running program or cancel the reserve setting, you need to switch off the power and make new selection.

Confirm it's horizontal:

Hang the lead line to check if it is horizontal.

Adjust the adjustable leg:

1 .To twist the adjustable leg, please first lift up the side of the leg slightly, loosen the adjustable nut, and twist the leg.

2 . After adjustment, fasten the nut.

Loosen

High

the adjustable nut

Fasten

the adjustable feet

Low

7 Push the "Start/Pause" button

6 Finish washing

After finishing wash it'll alarm automatically