CANDELIER™
CANOPY ELECTRICAL CONNECTIONS
Step 6a. Attach the fan wires (coming from the downrod) to the ceiling fixture outlet box wiring by placing the bare ends of the wires side by side and then securing with a wire nut. Test that the connection is secure by pulling on the wire nut. Connect in this order:
•GREEN wire leads from mounting plate and downrod assembly of fan to GROUND conductor of power source. Secure with a wire nut.
•WHITE wire from fan connects to white NEUTRAL wire in ceiling fixture outlet box. Secure with wire nut.
•BLACK power wire from fan connects to BLACK power wire in ceiling outlet box. Secure with wire nut.
After making the wire connections, the wires should be spread apart with the grounded conductor and the equipment- grounding conductor on one side of the outlet box and the ungrounded conductor on the other side of the outlet box.
NOTE: If your ceiling wires are different from those described above, consult an electrician.
Step 6b. After connecting wiring, slide the canopy cover up and into place. Make sure the canopy cover tabs are properly aligned with the canopy bracket and securely locked into place.
FAN BLADE INSTALLATION
PARTS NEEDED FOR THIS SECTION:
FAN BLADE HARDWARE (not to scale)
Fan Blades
Blade Screws | Washers | Motor End Cap |
|
|
|
Step 7a. Unscrew the bottom cover fitter plate and set the cover and screws aside. You will reinstall them in Step 7c.
Step 7b. Make sure that the label “THIS SIDE UP” is not visible when the blades are installed. Please note the label is installed on the actual fan blades. Insert the first fan blade into one of the slanted opening beneath the control housing. Secure the blade with black blade screws and washers (3 screws and washers per blade). Repeat this process until all three blades are installed.
Step 7c.
7
