INTELI•TOUCH™ CONTROL INSTALLATION
INSTALLING THE W-32 WALL CONTROL
The wall control installs in the same manner as an ordinary light switch, using an existing wall box and wiring. This controller is designed to signal the fan microcomputer as well as perform normal switching operations. For this reason the following precautions must be observed:
1.Use only the Casablanca
2.Do not use any additional control with your
3.Do not use more than one fan per wall control.
4.No other light fixtures or electrical appliances may be connected on the circuit controlled by the
INTELI•TOUCH™ SINGLE W-32 INSTALLATION
CAUTION!
Ensure power is turned OFF at the breaker or fuse panel before starting installation.
1.Remove the screws and switch plate from the existing switch box.
2.Remove the screws holding the switch in the switch box.
3.Pull the existing switch from the switch box to expose the wire connections.
4.Remove the two wires from the switch.
5.Connect the two wires just removed from the switch to the
6.Connect the green ground wire coming from the back of the
7.Install the
8.Install the wall plate with the two color matched screws.
NOTE: If wall control operation is reversed (fan switch controls lights and light switch controls fan) turnoff the power at the breaker or fuse panel, then swap the two
INTELI•TOUCH™ DUAL W-32 INSTALLATION
CAUTION!
Ensure power is turned OFF at the breaker or fuse panel before starting installation.
To control the fan and lights from two locations (a
1.Remove the screws and switch plate from the existing switch box and the screws holding the switch in the switch box.
2.Pull the existing switch from the switch box to expose the wire connections.
3Determine which wire is connected to the common terminal of the
4.Remove the wire from the common terminal of the
5.Remove the two remaining wires from the
6.Connect the green ground wire coming from the back of the
7.Install the
8.Install the wall plate with the two short
9.Installation of the second
NOTE: If wall control operation is reversed (fan switch controls lights and light switch controls fan) turn off the power at the breaker or fuse panel, then swap the two
10