CANDELIER™
CANOPY BRACKET INSTALLATION
PARTS NEEDED FOR THIS SECTION:
CANOPY BRACKET HARDWARE (not to scale)
|
| Wood | Long Wood | Sheetrock |
|
Canopy Bracket | Grommets | Screws | Screws | Anchor | Washers |
Step 2a. Hold the canopy bracket up to the ceiling with the ‘lip’ side facing the floor. Use a pen or pencil to mark screw placement through the holes in the bracket.
Step 2b. Insert three black rubber grommets to the canopy bracket as shown. The bracket is then installed facing the ceiling.
Step 2c. Drill holes on both sides of canopy bracket for even support. Select the set of screws most appropriate for your installation.
Step2d. Use one of the following screw combinations: A. Wood screws and washers
B. Long wood screws and washers C. Sheetrock anchors
Option 1: Using Wood Screws
Install screws and washers through the holes in the canopy bracket.
Tighten screws until they are secure against the ceiling.
Option 2: Using Sheetrock Anchors
Install sheetrock anchors through the holes in the canopy bracket.
Tighten anchors until they are secure against the ceiling.
INSTALLING CANOPY COVER
PARTS NEEDED FOR THIS SECTION:
CANOPY COVER HARDWARE (not to scale)
Downrod
Screws
Support | Downrod | Canopy |
Ring | Cover | Cover |
Step 3a. Slide the hanging bracket support ring on to the downrod. Then, slide the downrod cover over the downrod. The base of the downrod should sit securely on the rubber gasket inside the downrod cover.
Step 3b. Place the downrod (with the downrod cover attached) inside the canopy cover. The edge of the downrod cover should sit securely on the rubber gasket inside the canopy cover.
5
