LG Electronics D2532W, D5932W, D5911W, D2511W manual Electrical Requirements GAS Dryer, Gas Dryers

Page 16

ELECTRICAL REQUIREMENTS - GAS DRYER

Customer Service Troubleshooting Tips Operating Instruction Installation Instructions Safety Instructions

Gas Dryers

(120 Volt, 60 Hertz, with 3-Prong Grounding Plug)

NOTE : The wiring diagram is located inside the control panel, inside the control cabinet.

WARNING

To reduce the risk of fire, electric shock or personal injury, all wiring and grounding MUST confirm with the latest edition of the National Electrical Code ANSI/NFPA 70 or the Canadian Electrical Code, CSA C22.1, and such local regulations as might apply. It is the customer’s responsibility to have the wiring and fuses checked by a qualified electrician to make sure the laundry room has adequate electrical power to operate the dryer.

The dryer is designed to be operated on a separate branch, polarized, three-wire, effectively grounded, 120 Volt, 60 Hertz, AC (alternating current) circuit protected by a 15 Ampere fuse, equivalent fusetron or circuit breaker.

The three-prong grounding plug on the power cord should be plugged directly into a polarized three-slot effectively grounded receptacle rated 120 Volts AC (alternating current) 15 Amps. Refer to Figure 22 to determine correct polarity of the wall receptacle.

WARNING

This dryer is equipped with a three- prong (grounding) plug for your protection against shock hazard and should be plugged directly into a properly grounded three-prong receptacle. Do not cut or remove the grounding prong from this plug.

NOTE : A qualified electrician should check the polarity of the wall receptacles. If a voltage reading is measured other than that illustrated, the qualified electrician should correct the problem.

DO NOT OPERATE OTHER APPLIANCES ON THE SAME CIRCUIT WHEN THIS APPLIANCE IS OPERATING. DO NOT OVERLOAD CIRCUITS!

DO NOT operate both a washer and gas dryer on the same circuit. Use separately fused 15 Amp circuits.

WARNING

To reduce the risk of an electric shock or fire, DO NOT use an extension cord or an adapter to connect the dryer to the electrical power source.

DO NOT OVERLOAD

CIRCUITS

DO NOT USE AN

ADAPTER

DO NOT USE AN

EXTENSION CORD

1 6

Image 16
Contents Electric and Gas Dryer Table of Contents Before Using Your NEW DryerWhat to do if YOU Smell GAS Important Safety Instructions Important Safety InstructionsLG Dryer Warranty RequirementsInstallation Instructions Installation clearancesMinimum installation spacing for a recessed InstallationInstalling the Dryer Failure to exhaust dryer properly will void warrantyPosition and Level the Dryer Connect Dryer Exhaust SystemConnect Gas Supply Pipe Gas Dryer only RequirementsHeat Source Check Door Reversal Procedure Manufactured Mobile Home Installation Electrical Requirements Electrical Dryer Grounding InstructionsWire connection Power supply cord Wire connection Direct wire12.7cm Wire connection Direct wire Electrical Requirements GAS Dryer Grounding Instructions GAS Requirements Supply line requirementsExhaust System Materials Exhaust RequirementsExhaust System Maximum length of 4 10.2 cm diameter rigid metal duct Maximum length of 4 10.2 cm diameter flexible metal ductExhaust System Maintenance Dryer AirflowUser Maintenance Cleaning the Lint ScreenFeatures and Benefits Starting Your Dryer Fire Hazard No washer can completely remove oilPausing or Restarting To use a Sensor Dry CycleTo use a Manual Dry Cycle Stopping Your DryerCycle Descriptions Modifiers OptionsTo store a Custom Program To use the Rack DRYTo recall your stored Custom Program Before YOU Call for Service Problem Possible Causes What To DoService Telephone Numbers LG Dryer Limited Warranty USA