USER MAINTENANCE
Instructions |
| Lubrication | ||
|
| |||
|
| All moving parts are sealed in a permanent supply of | ||
|
| Iubricant or are equipped with oilless bearings. | ||
|
| Additional lubrication will not be necessary. | ||
Safety |
| Care of Your Dryer | ||
| Clean the lint filter before drying each load. The lint | |||
|
| |||
|
| filter may be washed if needed. Annually remove the lint | ||
|
| filter and attach to the vaccuum duct under it. | ||
Instructions |
| Ordinarily, the dryer cylinder will need no care. | ||
|
| |||
|
| Wipe the exterior dryer cabinet as needed. If detergent, | ||
|
| bleach or other washing products are spilled on the | ||
|
| cabinet, wipe immediately. Some products will cause | ||
Installation |
| permanent damage if spilled on the cabinet. | ||
| Use only a damp cloth for cleaning the control panel. | |||
|
| |||
|
| Some spray prewash products may harm the finish on | ||
|
| the control panel. | ||
|
| NOTE: The wiring diagram is located inside the | ||
|
| control panel. | ||
Instruction | ||||
|
|
| ||
|
| WARNING | ||
|
|
| ||
|
|
|
| |
|
| Label all wires prior to disconnection when | ||
Operating |
| servicing controls. Wiring errors can cause | ||
| improper and dangerous operation. | |||
|
| |||
|
|
|
| |
|
|
|
| |
Troubleshooting Tips |
|
|
| |
|
|
|
| |
Customer Service |
|
|
| |
|
|
|
| |
Cleaning the Lint Screen
Every load cleaning
The lint screen is located in the door opening of the dryer. Clean it before or after each load. A screen blocked by lint can increase drying time.
To clean
1. Pull the lint screen straight up. Roll lint off the screen with your fingers. Do not rinse or wash screen to remove lint. Wet lint is hard to remove.
2. Push the lint screen firmly back into place.
IMPORTANT:
■Do not run the dryer with the lint screen loose, damaged, blocked, or missing. Doing so can cause overheating and damage to both the dryer and fabrics.
■Some towels made of synthetic fibers and natural fibers (polyester and cotton blends) may shed more lint than other towels, causing your dryer's lint screen to fill up faster. Be sure to remove lint from the lint screen before and after drying new towels.
■If lint falls off the screen into the dryer during removal, check the exhaust hood and remove the lint.
As needed cleaning
Laundry detergent and fabric softener residue can build up on the lint screen. This buildup can cause longer drying times for your clothes, or cause the dryer to stop before your load is completely dry. The screen is probably clogged if lint falls off the screen.
Clean the lint screen with a nylon brush every six months, or more frequently, if it becomes clogged due to a residue buildup.
To wash
1. Roll lint off the screen with your fingers.
2. Wet both sides of lint screen with hot water.
3. Wet a nylon brush with hot water and liquid detergent. Scrub lint screen with the brush to remove residue buildup.
4. Rinse screen with hot water.
5. Completely dry lint screen with a clean towel. Replace screen in dryer.
2 2