GE GFDS355, GFDN245, GFDS350, GFDN240, 234D1050P001 Dry Temp, My Cycle, Clean Lint Filter message

4 Sensor Dry “Level”

The sensor continuously monitors the amount of moisture in the load.. When the moisture in your clothes reaches your selected dry level, the dryer will stop..

Note: Sensor dry “LEVEL” only works for COTTONS, NORMAL/MIXED LOAD, ACTIVE WEAR, DELICATES, and SPEED DRY..

5		Dry “Temp”
		You can change the temperature of your dry cycle..
			This option may only be used with COTTONS or NORMAL/MIXED LOAD cycles.. This option reduces
	ANTI-BACTERIAL

(on some models) certain types of bacteria by 99..9%, including: Staphylococcus aureus, Pseu- domonas aeruginosa and Klebsiella pneumoniae*.. The anti-bacterial process occurs when high heat is used during a portion of this drying cycle..

NOTE: Do not use this cycle on delicate fabrics..

*The Anti-Bacterial Cycle is Certified by NSF International (formerly National Sanitation Foundation) to NSF Protocol P154 Sanitization Performance of Residential Clothes Dryers.

HIGH	For regular to heavy cottons..
MEDIUM	For synthetics, blends and items labeled permanent press..
LOW	For delicates, synthetics and items labeled Tumble Dry Low..
EXTRA LOW	For lingerie and special-care fabrics..

6 START

Press to start a dry cycle.. If the dryer is running, press it once and it will pause the dryer..

Press it again to resume the dry cycle..

7 My Cycle

Set up your favorite combination of settings and save them here for one touch recall..

These custom settings can be set while a cycle is in progress..

To store a MY CYCLE combination of settings:

1.Select your drying cycle..

2.Change DRY “TEMP”, and SENSOR DRY “LEVEL” settings to fit your needs..

3.Select any drying OPTIONS you want..

4.Press and hold the pad for three seconds to store your selection.. A beep will sound and the pad will light

up..

To recall your stored MY CYCLE combination:

Press the MY CYCLE button before drying a load..

To change your stored MY CYCLE combination:

Follow steps 1–4 in “To store a MY CYCLE combination of settings”..

8 “CLEAN LINT FILTER” (message)

(This message represents only a reminder and does not always appear when filter needs cleaning.. The filter should be cleaned after every drying cycle is complete..)

This message will disappear after the START button is pressed.. Even though you may have already cleaned the filter (before or after the POWER button has been pressed), the “CLEAN LINT FILTER” message will still be displayed until the START button is activated..

8