Reversing the door swing.
STEP-BY-STEP INSTRUCTIONS (cont.)
Remove
Top Screw
Remove Door Assembly
2. Open the door to approximately 130 degrees..
3. Remove the 2 screws starting from the bottom to the top.. Make sure the door is supported while removing the screws..
4. Loosen the top screw as shown.. Unhook the door by lifting and pulling..
4 Beauty Buttons
5.Place the door on a soft protected flat surface so the inner door faces upward (door
resting on handle side).. Remove the 8 tapping screws located around the perimeter of the door outlining the gasket.. Remove the 6 machine screws.. Using a putty knife or any other flat tool, remove the 2 beauty buttons and install them on the opposite side..
Outer Door Assembly | Remove Hinge and Cover | |
| ||
|
| IMPORTANT: Note the location of the hinge (left or right) before removing.. |
|
| 6. With the screws removed, turn the door over and separate the outer door |
|
| assembly and hinge cover of the door from the door frame and set aside.. |
Hinge Assembly | Hinge Cover |
|
|
|
12