Exhaust venting
WARNING
Fire Hazard
Use heavy metal exhaust duct.
Do not use a plastic exhaust duct.
Do not use thin metal foil exhaust duct.
Failure to do so can result in death or fire.
1.Read the exhaust section (page
Do not use sheet metal screws when assembling ducting. Always use suitable duct tape. Never use plastic or thin metal foil flexible exhaust material.
2.The exhaust outlet is located close to the center of the rear of the dryer. Make sure you join the exhaust duct to the dryer with duct tape only. This will prevent lint and dust from escaping from the dryer and exhaust system.
Exhaust outlet
| 4 | (111mm) |
| " |
|
| 8 |
|
| 3/ |
|
13 7/8" (352mm) | 13 1/8" (333mm) |
|
3.The exhaust vent can be routed up, down, left, right or straight out the back of the dryer. Refer to diagram.
13