Fisher & Paykel DEGX1US installation instructions Mobile home installation

Page 7

Mobile home installation

The installation of the dryer in a mobile home must conform to the Manufactured Home Construction and Safety Standard Title 24 CFR, Part 32-80 {formerly the Federal Standard for Mobile Home Construction and Safety, Title 24 HUD (Part 280), 1975} for the United States.

When installing a dryer in a mobile home, provisions for anchoring the dryer to the floor must be made.

A Mobile Home Installation kit is available with instructions (see Accessories page 3). Locate in an area that has adequate make up air (a minimum of 72 square inches of unobstructed opening is required).

Mobile home installations must be exhausted to the outdoors with the exhaust duct termination securely fastened to the mobile home structure, using materials that will not support combustion.

The exhaust duct must not terminate beneath the mobile home. See the section on exhausting for more information.

��� ����� ���� ��

��������� �������

�������

����

�����

�������� ����

 

��������

���������� ���� ���� �� ��������

�������� �� � ���������������

������� �� ��� ������ ����

��������� ��� ���� ��� ���������

������� ��� ������ �����

7

Image 7
Contents Installation instructions Important safety instructions Parts supplied Read this before you start installing your dryerAccessories Tools requiredLocation requirements To the installerExplosion Hazard Alcove or closet installation Lid clearance DimensionsExhaust outlet location Mobile home installation Fire Hazard ExhaustingDetermine vent duct length Maximum length of exhaust duct Preferred 4 Hoods Alternative installation for close clearances Exhaust venting Remove packaging InstallationExcess Weight Hazard UnpackingFitting the front feet Electric Shock Hazard Electrical requirements208V Requirements Grounding for a permanently connected appliance Grounding instructionsElectrical Shock Hazard Grounding for a cord-connected applianceConnecting by direct wire Power supply cord requirements for U.S.AFor 4-wire connections by direct wiring For 3-wire connections by power cordsFor 3-wire connections by direct wiring For 4-wire connections by power cordsRemove the terminal block cover plate Wire connectionsWire connections plus separate grounding connector Wire connections Level machine Final installation check listInstallation Instructions Published 03/2004 Part No a