Level machine
Check the dryer is level, and make necessary adjustments to the front levelling feet. The rear levelling feet are self adjusting.
Final installation check list
Check that: No plastic or flexible metal foil is used in the exhaust ducting. Exhaust is rigid ducting or thick wall flexible metal ducting. All joints in the ducting are made with duct tape – no screws are used. Ducting is clean and is connected to the dryer. Inserts are fitted to the two front feet. Dryer is level across the front. If installation is 208 V, special element kit has been fitted (see page 16). Dryer is plugged or directly wired into an approved fitting and is properly grounded. Dryer starts, heats, cools and shuts off. Customer has been shown how to use the dryer.
NB: This dryer has a drum reversal feature to reduce clothes tangle. Throughout the drying cycle the motor will run for four minutes, then stop & run in the opposite direction for forty seconds before reversing again.
23