Installation Instructions 13
Electrical connection (non-Canada) - 4 wire cord
4-wire receptacle
(NEMA type 14-30R)
WARNING
ELECTRICAL SHOCK HAZARD
Failure to disconnect power source before servicing could result in personal injury or even death.
1.Turn off power supply to outlet.
2.Remove the screw securing the terminal block access cover in the lower corner on the back of the dryer.
3.Install a
4.Thread an UNPLUGGED,
SRDT, through the strain relief.
5.Disconnect the internal (BLACK) dryer harness ground wire from the (GREEN) ground screw next to the terminal block.
6.Attach the ground (GREEN) power cord wire to the cabinet with the ground (GREEN) screw.
Tighten the screw securely.
7.Move the internal dryer harness ground (BLACK) wire to the terminal block and attach it along with the neutral (WHITE) power cord wire conductor to the center, SILVER colored terminal on the terminal block. Tighten the screw securely.
|
| Neutral |
30 AMP | Ground | (WHITE wire) |
| ||
(GREEN wire) |
| |
NEMA |
| |
|
|
Access cover
screw
Terminal
block
Line
2
(BRASS terminal)
Neutral
(SILVER terminal)
Line
1
(BRASS terminal)
Internal
ground (GREEN screw)
Install
strain relief here
Terminal
screw
recovery slot
NOTE
If a terminal screw falls during cord installation, it can be retrieved in the terminal screw recovery slot below the access panel.
8.Attach the RED and BLACK power cord conductors to the outer, BRASS colored terminals on the terminal block. Tighten both screws securely.
WARNING
ELECTRICAL SHOCK HAZARD
Do not make a sharp bend or crimp wiring/ conductor at connections.
9.Follow manufacturer’s guidelines for firmly securing the strain relief and power cord.
10.Reinstall the terminal block cover.
Move internal
ground (BLACK)
wire to neutral
(SILVER)
terminal
for
GREEN
ground screw
GREEN
ground wire
Neutral
terminal
WHITE
neutral
wire
BLACK or RED power wire
BLACK or
RED power wire