Electrolux 137018200 A, EWMED65H, 134912700, 134709300 Removing Latch Indicator Removing Hole Plug

Page 21

Reversing Door 21

E) Removing Latch Indicator

F) Removing Hole Plug

1Insert flat blade screwdriver into open slot of latch indicator.

2 Gently pry upward to release tab.

3 Pull the indicator out and set it aside.

1Insert flat blade screwdriver into open slot of hole plug.

2 Gently pry upward to release tab.

3 Pull the hole plug out and set it aside.

Image 21

Contents Installation Instructions Finding Information Table of contentsPlease read and save this guide Keep a record for quick referenceSafety Important Safety InstructionsPre-installation requirements Wire receptacle Nema type 10-30R Installation RequirementsWire receptacle Nema type 14-30R Electrical system requirementsExhaust system requirements Gas supply requirementsInstall male fittings in correct direction Exhaust direction Manufactured or mobile home installationClearance requirements Do not Install Your DryerInstalled dryer dimensions Installation Instructions Electrical installationGrounding requirements Electric dryer USA Grounding requirements Gas dryer USA and Canada Grounding requirements Electric dryer CanadaElectrical connection non-Canada 3 wire cord Electrical connection non-Canada 4 wire cord Todryer Gas connectionWater connection Steam Model only Water connection, con’t Steam Model only General installation Performing Installation Cycle Preparing to reverse door swing Reversing DoorRemoving door and hardware Removing Trim RingReversing Hardware on Front Panel Removing Door Hardware Reversing doorRemoving Latch Indicator Removing Hole Plug Reinserting Hole Plug Reinserting Latch IndicatorReattaching Latch Plate Reattaching HingeReattaching Door to Front Panel Reinstalling Trim Plug Reinstalling Trim RingReversing Trim Ring Plug in dryer and continue operationReplacement parts 1-877-4ELECTROLUX OptionsAccesories