American Dryer Corp MDG-50 installation manual Must be Provided

Page 23

NOTE: Component failure due to improper voltage application will VOID THE WARRANTY.

3.Grounding

A ground (earth) connection must be provided and installed in accordance with state and local codes. In the absence of these codes, grounding must conform to applicable requirements of the National Electric Code ANSI/NFPA NO. 70-LATEST EDITION or in Canada, Canadian Electrical Codes Parts 1 & 2 CSA C22.1-1990 or LATEST EDITION (for Electrical Connections). The ground connection may be to a proven earth ground at the location service panel.

For added personal safety, when possible, it is suggested that a separate ground wire (no. 18 minimum) be connected from the ground connection of the dryer to a grounded cold water pipe. DO NOT ground to a gas pipe or hot water pipe. The grounded cold water pipe must have metal to metal connection all the way to the electrical ground. If there are any nonmetallic interruptions, such as, a meter, pump, plastic, rubber, or other insulating connectors, they must be jumped out with no. 4 copper wire and securely clamped to bare metal at both ends.

IMPORTANT: For personal safety and proper operation, the dryer must be grounded.

Provisions are made for ground connection in each dryer at the electrical service connection area.

4.Electrical Connections

A wiring diagram is located inside the control box for connection data.

NOTE: A CIRCUIT SERVING EACH DRYER

MUST BE PROVIDED.

1)Single-Phase (1ø) Wiring Connections and Hookup

The electrical input connections on ALL single-phase (1ø) dryers are made into the rear service box lo- cated at the upper left area of the dryer.

19

Page 22 Page 24
Image 23
Page 22 Page 24
Contents MDG-50 Installation Manual Retain This Manual In a Safe Place For Future Reference For Your Safety Page Table of Contents Section Routine Maintenance Important Information SectionPersonal Injury or Fire could Result Safety PrecautionsPage Specifications SpecificationsSpecifications Unpacking and Setting UP Installation ProceduresLocation Requirements Dryer Enclosure Requirements Fresh AIR Supply Exhaust Requirements Single Dryer Venting Illus. B Multiple Dryer Common Venting ILLUS. D Importantventingreminders Electrical Requirements Electrical InformationMust be Provided Odfn Klwh Uhhq Important a Circuit Serving Each Dryer Must be Provided DG-50 GAS Injury and Improper Operation of the Dryer GAS InformationType of GAS Page Page Preparation for Operation and START-UP Preoperational Tests Preoperational Instructions Page OPL Models Shut Down Instructions Parts ServiceSection Returning Warranty CardsCleaning Routine MaintenanceLubrication AdjustmentsDrive motor not operating does not start TroubleshootingNo L.E.D. light emitting diode display Blower motor not operating does not start Microprocessor controller computer display reads door Microprocessor computer display reads dSFLNo heat, ignitor sparks, burner goes on and off right away Dryer operates but is taking too long to dry Dryer or scraping noise at basket tumbler area Condensation on main door glassDrive motor only not operating Excessive noise or vibrationMain burners are burning with a yellow flame Dryer operates but is taking too long to dry load Heating unit not operating ALL temperature selectionsBlower motor only not operating Dryer is cycling on hi-limit thermostat Data Label Technical InformationSerial Number Timing Legend Reversing Timer SPIN/DWELL AdjustmentsProcedure for Functional Check Replacement Components Direct Spark Ignition DSI System 10/30/00-150
Top Page Image Contents