American Dryer Corp MDG-50 installation manual Service, Parts

Page 37

SECTION IV

SERVICE and PARTS INFORMATION

A. SERVICE

1.Only competent or trained technicians should service the dryer. If service is required, contact the distributor from whom the Maytag Company equipment was purchased. If the distributor cannot be contacted or is unknown, contact the Maytag Company Service Department for a distributor in your area.

NOTE: When contacting the Maytag Company Service Department, be sure to give them the correct model and serial numbers so that your inquiry is handled in an expeditious manner.

B. PARTS

1.Replacement parts should be purchased from the distributor from whom the Maytag Company equipment was purchased. If the distributor cannot be contacted or is unknown, contact the Maytag Company for a distributor in your area.

NOTE: When ordering replacement parts from the Maytag Company dealer or the Maytag Company, be sure to give them the correct model and serial numbers so that your parts order can be processed in an expeditious manner.

33

Image 37
Contents MDG-50 Installation Manual Retain This Manual In a Safe Place For Future Reference For Your Safety Page Table of Contents Section Routine Maintenance Important Information SectionPersonal Injury or Fire could Result Safety PrecautionsPage Specifications SpecificationsSpecifications Unpacking and Setting UP Installation ProceduresLocation Requirements Dryer Enclosure Requirements Fresh AIR Supply Exhaust Requirements Single Dryer Venting Illus. B Multiple Dryer Common Venting ILLUS. D Importantventingreminders Electrical Requirements Electrical InformationMust be Provided Odfn Klwh Uhhq Important a Circuit Serving Each Dryer Must be Provided DG-50 GAS Injury and Improper Operation of the Dryer GAS InformationType of GAS Page Page Preparation for Operation and START-UP Preoperational Tests Preoperational Instructions Page OPL Models Shut Down Instructions Parts ServiceSection Returning Warranty CardsCleaning Routine MaintenanceLubrication AdjustmentsNo L.E.D. light emitting diode display TroubleshootingDrive motor not operating does not start Blower motor not operating does not start Microprocessor controller computer display reads door Microprocessor computer display reads dSFLNo heat, ignitor sparks, burner goes on and off right away Dryer operates but is taking too long to dry Dryer or scraping noise at basket tumbler area Condensation on main door glassMain burners are burning with a yellow flame Excessive noise or vibrationDrive motor only not operating Blower motor only not operating Heating unit not operating ALL temperature selectionsDryer operates but is taking too long to dry load Dryer is cycling on hi-limit thermostat Data Label Technical InformationSerial Number Timing Legend Reversing Timer SPIN/DWELL AdjustmentsProcedure for Functional Check Replacement Components Direct Spark Ignition DSI System 10/30/00-150