American Dryer Corp MDG-30 installation manual Specifications

Page 10

SECTION II

SPECIFICATIONS

A. SPECIFICATIONS

MAXIMUM CAPACITY (DRY WEIGHT)		30 lbs		13.6 kg

BASKET (TUMBLER) DIAMETER		30”		76.2 cm

BASKET (TUMBLER) DEPTH		30”		76.2 cm

BASKET (TUMBLER) MOTOR		1/2 hp*		0.373 kW

DOOR OPENING (DIAMETER)		21-1/2”		54.61 cm

BASKET (TUMBLER) VOLUME		12.27 cu ft		0.347 cu m

DRYERS PER 20’/40’ CONTAINER			12/28

DRYERS PER 45’/48’ TRUCK			32/36

	VOLTAGE AVAILABLE	120-460v 1ø 50/60 Hz

	APPROX. WEIGHT (UNCRATED)	535 lbs		242.7 kg
GAS
GAS	APPROX. WEIGHT (CRATED)	585 lbs		265.4 kg
	APPROX. WEIGHT (CRATED)	585 lbs		265.4 kg

	HEAT INPUT	90,000 Btu/hr		22,680 kcal/hr

	AIRFLOW	600 cfm		17 cmm

	INLET PIPE CONNECTION	1/2” M.N.P.T.**

Shaded areas are stated in metric equivalents			07/21/03

* Reversing dryer available with 3-phase (3ø) 1/2 hp (0.373 kW) motors standard.

** Size of piping to dryer varies with installation conditions. Contact factory for assistance.

NOTE: Manufacturer reserves the right to make changes in specifications at any time without notice or obligation.

6

Image 10

Contents MDG-30 Coin Installation Manual Retain This Manual In a Safe Place For Future Reference Foryour Safety Page Table of Contents Section Procedure for Functional Check of Replacement Important Information Receiving and HandlingSafety Precautions What to do if YOU Smell GASPage Specifications SpecificationsSpecifications GAS only Installation Procedures Unpacking and Setting UPLocation Requirements Dryer Enclosure Requirements Fresh AIR Supply Requirements Exhaust Requirements Single Dryer Venting Vertical Venting Multiple Dryer Common Venting Illus. D Importantventingreminders Electrical Information Electrical RequirementsMust be Provided Single-Phase 1ø Electrical Connections Leads GAS 120GAS Information Rating Kcal/hr22,680 This Pipe Size Requirement Page Preparation for Operation and START-UP Preoperational Tests Preoperational Instructions Basket Tumbler CoatingPage Select Temperature Shutdown Instructions Service SERVICE/PARTS InformationParts Returning Warranty Cards Warranty InformationWarranty Cleaning Routine MaintenanceSuggested Cleaning Schedule Adjustments LubricationNo light emitting diode L.E.D. display TroubleshootingDrive motor is not operating does not start Blower motor is not operating does not start Microprocessor controller computer display reads dSFLMicroprocessor controller computer display reads door No heat, ignitor sparks, burner goes on and off right awayDryer operates but is taking too long to dry Dryer is making scraping noise at basket tumbler area Condensation on main door glassExcessive noise or vibration Main burners are burning with a yellow flame Heating unit is not operating all temperature selectionsDryer operates but is taking too long to dry load Dryer is cycling on hi-limit thermostat Datalabel Information Data LabelSerial Number Procedure for Functional Check Replacement Components Page Page Burner Manual Reset HI-LIMIT Instructions 12/15/99-150