NOTE: If computer program changes are required, refer to the computer programming section of the manual supplied with the dryer.
6.The dryer should be operated through one (1) complete cycle to assure that no further adjustments are necessary and that ALL components are functioning properly.
BASKET (TUMBLER) COATING
The basket (tumbler) is treated with a protective coating. We suggest dampening old garments or cloth material with a solution of water and nonflammable mild detergent and tumbling them in the basket (tumbler) to remove this coating.
7.Check the electric service phase sequence
IMPORTANT: If the blower wheel (impellor/fan) is rotating in the wrong direction, this will not only drastically reduce drying efficiency, but it can also cause premature component failure.
J. PREOPERATIONAL INSTRUCTIONS
COIN MODELS
1.Automatic Mode (Microprocessor Controller [Computer] Models)
a.When turning on power or when no cycle is in progress, the light emitting diode (L.E.D.) display will read “FILL” or “Amount To Start.”
b.Insert coins.
Once correct “Amount To Start” has been inserted the L.E.D. display will read “PUSH.”
c.Select temperature by pushing “HI TEMP,” “LO TEMP,” or “PERM PRESS.” The dryer will start, the L.E.D. display will read the temperature cycle selected, and the drying time portion of the L.E.D. display will read “00” and count upward as time elapses.
IMPORTANT: If the door is opened during a cycle, both the heat and motor will stop. However, the microprocessor controller (computer) will continue to count downward in time. Continuation of the cycle will resume only after the door has been closed and any other of the three (3) temperature selection buttons is again depressed.
d.Once the preprogrammed dryness level and cool down period have been reached, or the maximum automatic time has expired, the tone (buzzer) will sound for
28