American Dryer Corp ADG-78 II Unpacking/Setting Up, Bracket Before Starting the Dryer

Page 15

B. UNPACKING/SETTING UP

Remove protective shipping material (i.e., plastic wrap, and/or optional shipping box) from dryer.

IMPORTANT : Dryer must be transported and handled in an upright position at ALL times.

The dryer can be moved to its final location while still attached to the skid or with the skid removed. To un-skid the dryer, locate and remove the four (4) bolts securing the base of the dryer to the wooden skid. Two (2) are at the rear base (remove the back panel for access), and two (2) are located in the bottom of the lint chamber. To remove the two (2) bolts located in the lint chamber area, remove the lint door.

To increase bearing life and improve efficiency, the dryer should be tilted slightly to the rear.

The lint coops of ALL ADG-78 II dryers are supported during shipping by a bracket. REMOVE THIS

BRACKET BEFORE STARTING THE DRYER.

If more headroom is needed when moving dryer into position, the top console (module) may be removed. a. To remove top console (module)

1)Disconnect the ground wire (A) at the Rear Upper Left Hand Corner of Dryer.

2)Remove the four (4) set of nuts and washers (B) holding the console (module) to base.

3)Open the control door/control panel and disconnect the white 9-pin plug connector (C in the illustration below) located in the base of the control box.

4)Disconnect motor harness(es) (D) located in rear Electrical Box.

5)Disconnect (2) pin connector (E) located in rear Electrical Box. (on some machines this is optional)

6)Lift the console (module) off the dryer base.

IMPORTANT: The dryer must be transported and handled in an upright position at all times.

11

Page 14 Page 16
Image 15
Page 14 Page 16
Contents ADG-78 Retain This Manual In a Safe Place For Future Reference For Your Safety Page Table of Contents Section Routine Maintenance Important Information SectionWhat to do if YOU Smell GAS Safety PrecautionsNational Electric Code ANSI/NFPA no -LATEST Edition Specifications SPECIFICATIONS/COMPONENT IdentificationSpecifications Component Identification Page Location Requirements Installation ProceduresBracket Before Starting the Dryer UNPACKING/SETTING UPDryer Enclosure Requirements Fresh AIR Supply Page Exhaust Requirements Reduced Anywhere Down Stream of the Dryer Reduced Anywhere Down Stream of the Dryer Page Electrical Information ADG-78 II Gas Page Black Positive White Neutral Green Ground Page GAS Information Type of GAS Page Page Preparation for OPERATION/START-UP Preoperational Tests Page Shut Down Instructions Preoperational InstructionsSERVICE/PARTS Information ServiceParts Warranty Information Returning Warranty CardsReturning Warranty Parts Page Cleaning Routine MaintenanceDays AdjustmentsData Label Data Label LOCATION/INFORMATIONSerial Number Procedure for Functional Check Replacement Components Burner flame must shut off immediately ADC 113101 1- 09/01/99-30
Top Page Image Contents