American Dryer Corp ADG-78 II Preoperational Instructions, Shut Down Instructions

Page 35

K. PREOPERATIONAL INSTRUCTIONS

1.To start the dryer...

a. Microprocessor (computer) dryers...

1)The L.E.D. (light emitting diode) display will read "FILL".

2)Press the "E" on the touchpad of the keyboard.

3)The L.E.D. display will quickly show "Ld30," "F180." The dryer will start, and the L.E.D. display will show "dr30."

Refer to the User's Manual for detailed operating instructions.

b.Dual Timer dryers...

1)Turn drying timer knob for a time of 20 minutes.

2)Select "High Temp."

3)Push "Push To Start" switch.

4)To stop dryer, open the main door.

L.SHUT DOWN INSTRUCTIONS

If the dryer is to be shut down (taken out of service) for a period of time, the following MUST BE performed;

1.Discontinue power to the dryer either at the external disconnect switch or the circuit breaker.

2.Discontinue the heat supply:

a. GAS MODELS ... discontinue the gas supply.

1)SHUT OFF external gas supply shut-off valve.

2)SHUT OFF internal gas supply shut-off valve located in the gas valve burner area.

31

Image 35
Contents ADG-78 Retain This Manual In a Safe Place For Future Reference For Your Safety Page Table of Contents Section Routine Maintenance Important Information SectionWhat to do if YOU Smell GAS Safety PrecautionsNational Electric Code ANSI/NFPA no -LATEST Edition Specifications SPECIFICATIONS/COMPONENT IdentificationSpecifications Component Identification Page Location Requirements Installation ProceduresBracket Before Starting the Dryer UNPACKING/SETTING UPDryer Enclosure Requirements Fresh AIR Supply Page Exhaust Requirements Reduced Anywhere Down Stream of the Dryer Reduced Anywhere Down Stream of the Dryer Page Electrical Information ADG-78 II Gas Page Black Positive White Neutral Green Ground Page GAS Information Type of GAS Page Page Preparation for OPERATION/START-UP Preoperational Tests Page Shut Down Instructions Preoperational InstructionsParts SERVICE/PARTS InformationService Returning Warranty Parts Warranty InformationReturning Warranty Cards Page Cleaning Routine MaintenanceDays AdjustmentsData Label Data Label LOCATION/INFORMATIONSerial Number Procedure for Functional Check Replacement Components Burner flame must shut off immediately ADC 113101 1- 09/01/99-30