American Dryer Corp AD-120ES II installation manual Electrical Service Specifications PER Dryer

2.Electrical Service Specifications

ADG-120ES II Reversing, 3ø (GAS) ADS-120ES II Reversing, 3ø (STEAM)

ELECTRICAL SERVICE SPECIFICATIONS (PER DRYER)

IMPORTANT: 208 VAC AND 240 VAC ARE NOT THE SAME. When ordering, specify exact voltage.

NOTES: A. When fuses are used they must be dual element, time delay, current limiting, class RK1 or RK5 ONLY. Calculate/determine correct fuse valve, by applying either local and/or National Electrical Codes to listed appliance amp draw data.

B.Circuit breakers are thermal-magnetic (industrial) motor curve type ONLY. For others, calculate/verify correct breaker size according to appliance amp draw rating and type of breaker used.

C.Circuit breakers for 3-phase (3ø) dryers must be 3-pole type.

SERVICE		WIRE	APPROX.		MINIMUM	FUSING		CIRCUIT
	PHASE					Dual Element
			AMP DRAW					BREAKER
VOLTAGE		SERVICE			WIRE SIZE	Time Delay
			60 Hz	50 Hz		60 Hz	50 Hz	60 Hz	50 Hz
208	3ø	3/4	11.8	---	*	20	---	20	---
240	3ø	3	13.0	16.7	*	20	25	20	25
380-400	3ø	3/4	---	8.0	*	15	---	15	---
416	3ø	3/4	---	8.4	*	15	---	15	---
460/480	3ø	3/4	7.0	---	*	15	---	15	---
575	3ø	3	5.8	---	*	15	---	15	---

*AWG Stranded Type Wire ... size wire as per National Electrical Code or local codes. (Motor lead type wire is recommended).

IMPORTANT: The dryer must be connected to the electric supply shown on the data label that is affixed to the left side panel/wall area behind the control door. In the case of 208 VAC or 240 VAC, the supply voltage must match the electric service specifications of the data label exactly.

WARNING: 208 VAC AND 240 VAC ARE NOT THE SAME. Any damage done to dryer components due to improper voltage connections will automatically VOID THE WARRANTY.

NOTE: ADC reserves the right to make changes in specifications at any time without notice or obligation.

23