Maytag MDG-30 Condensation on main door glass, Dryer or scraping noise at basket tumbler area

Page 45

6.Lint screen not being cleaned on a regular basis or often enough.

7.Extractors (washers) not performing properly.

8.Sail switch is fluttering, restriction in exhaust.

9.Failed microprocessor controller (computer), temperature calibration is inaccurate.

10.Failed microprocessor temperature sensor, calibration is inaccurate.

11.Failed burner or oven hi-limit.

12.Failed lint compartment hi-limit.

P.Condensation on main door glass

1.Too long, undersized, or improperly installed duct work.

2.Back draft damper is sticking in partially closed position.

Q.Dryer or scraping noise at basket (tumbler) area

1.Check for object caught in basket (tumbler) and wrapper area.

2.Basket (tumbler) is out of proper alignment

a.Check both vertical and lateral alignment.

b.Check gap between front panel and basket (tumbler) front, set screws may have come loose, and basket (tumbler) walked forward or backwards.

3.Loose basket (tumbler) tie rod.

4.Failed basket (tumbler) support.

R.Excessive noise or vibration

1.Dryer not leveled properly.

2.Impellor (fan and blower) out of balance

a.Excessive lint build up on impellor (fan and blower).

b.Failed impellor (fan and blower).

3.Loose basket (tumbler) tie rod.

4.Basket out of adjustment, or adjustment bolts (hardware) are loose.

5.Failed basket (tumbler) support.

6.Loose motor mount.

7.Failed idler or tumbler bearings.

8.V-belts either too tight or too loose.

41

Image 45

Contents MDG-30 Fast Dry Retain This Manual In a Safe Place For Future Reference For Your Safety Page Table of Contents Technical Information Section Personal Injury or Fire could Result Safety PrecautionsADJUSTING, INSTALLATION, or Testing Ofany Equipment per Osha Occupational Safety and HealthAdministration StandardsGAS Supply Before ANY Covers or Guards are Removed Super SpecificationsSpecifications MDG-30 Fast Dry Installation Procedures Location Requirements Dryer Enclosure Requirements Fresh AIR Supply Exhaust Requirements Single Dryer Venting Illus. B Multiple Dryer Common Venting ILLUS. D Importantventingreminders Electrical Requirements Electrical InformationMust be Provided Odfn Klwh Uhhq Important a Circuit Serving Each Dryer Must be Provided DG-30 Fast DRY GAS Injury and Improper Operation of the Dryer GAS Information$785$ Page Page Preparation for Operation and START-UP GAS Models only Preoperational TestsPreoperational Instructions Page OPL Models Shut Down Instructions Parts ServiceSection Returning Warranty CardsCleaning Routine MaintenanceLubrication AdjustmentsDrive motor not operating does not start No L.E.D. light emitting diode displayMicroprocessor computer display reads dSFL Blower motor not operating does not startNo heat, ignitor sparks, burner goes on and off right away Microprocessor controller computer display reads doorDryer operates but is taking too long to dry Condensation on main door glass Dryer or scraping noise at basket tumbler areaExcessive noise or vibration Heating unit not operating ALL temperature selections Main burners are burning with a yellow flameDryer operates but is taking too long to dry load Dryer is cycling on hi-limit thermostat Data Label Technical InformationSerial Number Procedure for Functional Check Replacement Components Direct Spark Ignition DSI System MAYTAG-113069 1-01/29/99-250