Maytag MDG-30 manual Table of Contents

Page 5

	Table of Contents
SECTION I
IMPORTANT INFORMATION		3
A. RECEIVING and HANDLING		3
B. SAFETY PRECAUTIONS		4
SECTION II
SPECIFICATIONS		6
SECTION III
INSTALLATION PROCEDURES		8
A. UNPACKING and SETTING UP		8
B. LOCATION REQUIREMENTS		9
C. DRYER ENCLOSURE REQUIREMENTS		10
D. FRESH AIR SUPPLY		11
E. EXHAUST REQUIREMENTS		12
F. ELECTRICAL INFORMATION		18
G. GAS INFORMATION		23
H. PREPARATION FOR OPERATION		27
I.	PREOPERATIONALTESTS	28
J.	PREOPERATIONAL INSTRUCTIONS	29
K. SHUT DOWN INSTRUCTIONS		32
SECTION IV
SERVICE AND PARTS INFORMATION		33
A. SERVICE		33
B. PARTS		33
SECTION V
WARRANTY INFORMATION		34
A. RETURNING WARRANTY CARDS		34
B. WARRANTY		34
SECTION VI
ROUTINE MAINTENANCE		35
A. CLEANING		35
B. ADJUSTMENTS		36

Image 5

Contents MDG-30 Fast Dry Retain This Manual In a Safe Place For Future Reference For Your Safety Page Table of Contents Technical Information Section Personal Injury or Fire could Result Safety PrecautionsGAS Supply Before ANY Covers or Guards are Removed ADJUSTING, INSTALLATION, or Testing Ofany Equipment perOsha Occupational Safety and HealthAdministration Standards Super SpecificationsSpecifications MDG-30 Fast Dry Installation Procedures Location Requirements Dryer Enclosure Requirements Fresh AIR Supply Exhaust Requirements Single Dryer Venting Illus. B Multiple Dryer Common Venting ILLUS. D Importantventingreminders Electrical Requirements Electrical InformationMust be Provided Odfn Klwh Uhhq Important a Circuit Serving Each Dryer Must be Provided DG-30 Fast DRY GAS Injury and Improper Operation of the Dryer GAS Information$785$ Page Page Preparation for Operation and START-UP GAS Models only Preoperational TestsPreoperational Instructions Page OPL Models Shut Down Instructions Parts ServiceSection Returning Warranty CardsCleaning Routine MaintenanceLubrication AdjustmentsDrive motor not operating does not start No L.E.D. light emitting diode displayMicroprocessor computer display reads dSFL Blower motor not operating does not startNo heat, ignitor sparks, burner goes on and off right away Microprocessor controller computer display reads doorDryer operates but is taking too long to dry Excessive noise or vibration Condensation on main door glassDryer or scraping noise at basket tumbler area Dryer operates but is taking too long to dry load Heating unit not operating ALL temperature selectionsMain burners are burning with a yellow flame Dryer is cycling on hi-limit thermostat Data Label Technical InformationSerial Number Procedure for Functional Check Replacement Components Direct Spark Ignition DSI System MAYTAG-113069 1-01/29/99-250