Maytag W10562335B, W10562339B-SP installation instructions Reverse the strike, Reinstall the door

Page 19

Reverse the strike

1.Remove the door strike from the dryer door opening.

2.Remove the cosmetic screw opposite the door strike.

A B

A. Door strike

B. Cosmetic screw

3.Reinstall the door strike and cosmetic screw on the opposite side of dryer door opening from where they were removed.

NOTE: Door strike and plugs must be on the same side of the dryer door opening.

Reinstall the door

1.Remove the 4 screws and two hinges from the dryer door.

2. Replace the 4 screws in the same holes

3.Remove the 4 screws from the opposite side of the door.

4.Install the two hinges to the front panel of the dryer using 4 screws. Use the non-slotted side to attach the hinge to the front panel.

5.Install screws in top hinge holes in the door. Do not tighten screws. Leave approximately 1/4" (5 mm) of screw exposed.

6.Hang door by placing screw heads into top slotted holes of hinges and slide door down. Align bottom screw holes in hinge and door. Install two bottom screws. Tighten all hinge screws.

7.Close door to engage door strike.

19

Image 19
Contents Electric Dryer Installation Instructions Dryer Safety Parts supplied steam models Installation RequirementsTools needed Parts supplied all modelsYou will need Location RequirementsElectrical Requirements If your outlet looks like this Install Leveling LegsIf connecting by direct wire Prepare dryer for leveling legsChoose electrical connection type Attach power supply cord strain reliefAttach power supply cord to strain relief Electrical ConnectionConnect remaining wires Connect neutral ground wire and neutral wireConnect ground wire Prepare to connect neutral ground wire and neutral wireRemove center screw Connect neutral wireAttach direct wire strain relief Direct Wire Strain ReliefWire Direct Wire Connection Prepare your 4-wire cable for direct connectionIf your wiring looks like this Optional 3-wire Connection Prepare your 3-wire cable for direct connectionVenting Connect external ground wireRigid metal vent Plan Vent System Determine vent path Whirlpool Vent System ChartAlternate installations for close clearances Special provisions for mobile homesConnect Inlet Hoses Install Vent SystemCheck for leaks Attach long hose to Y connector and tighten couplingsAttach long hose to dryer fill valve and tighten coupling Turn on cold water faucetMove dryer to final location Adjust leveling legsConnect Vent Level DryerSteam models only Complete Installation ChecklistRemove the door assembly Reverse Door SwingReverse the strike Reinstall the door2013 05/13 All rights reserved