INSTALLATION REQUIREMENTS
TOOLS AND PARTS
Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here.
Tools needed:
|
|
|
| #2 Phillips screwdriver | |
|
|
|
|
|
|
Adjustable wrench that | Level | |
opens to 1" (25 mm) or |
|
|
|
| |
|
|
|
|
|
|
Wire stripper (direct wire | Vent clamps |
installations) |
|
Parts supplied (all models):
Leveling legs (4) for models | Leveling legs (4) for models |
with riser | without riser |
Parts supplied (steam models):
|
|
|
|
|
|
“Y” connector |
| Short inlet hose |
|
|
|
|
|
|
5' (1.52 m) inlet hose | Rubber washer |
Caulking gun and compound (for installing new exhaust vent)
1/4" nut driver (recommended)
Pliers
Tin snips (new vent installations)
Tape measure
Parts package is located in dryer drum. Check that all parts are included.
Parts needed: (Not supplied with dryer)
Check local codes. Check existing electrical supply and venting. See “Electrical Requirements” and “Venting Requirements” before purchasing parts.
Mobile home installations require metal exhuast system hardware available for purchase from the dealer from whom you purchased your dryer. For further information, please refer to the “Assistance or Service” section in your “Use and Care Guide.”
Optional Equipment: (Not supplied with dryer)
Refer to your “Use and Care Guide” for information about accessories available for your dryer.
3