Maytag W10562339B-SP Attach long hose to Y connector and tighten couplings, Check for leaks

Page 16

4. Attach long hose to “Y” connector and tighten couplings

One end of the long hose has a wire mesh strainer inside the coupling. Attach this end to the “Y” connector. Attach washer cold inlet hose to other side of “Y” connector. Screw on coupling by hand until it is seated on connector. Using pliers, tighten the couplings an additional two-thirds turn.

NOTE: Do not overtighten. Damage to the coupling can result.

5. Attach long hose to dryer fill valve and tighten coupling

Attach other end of long hose to fill valve at bottom of dryer back panel. Screw on coupling by hand until it is seated on fill valve connector. Using pliers, tighten the couplings an additional two-thirds turn.

NOTE: Do not overtighten. Damage to the coupling can result.

6. Turn on cold water faucet

Check that the water faucets are turned on.

7. Check for leaks

Check for leaks around “Y” connector, faucets, and hoses.

Image 16

Contents Electric Dryer Installation Instructions Dryer Safety Installation Requirements Tools neededParts supplied all models Parts supplied steam modelsLocation Requirements You will needElectrical Requirements Install Leveling Legs If connecting by direct wirePrepare dryer for leveling legs If your outlet looks like thisAttach power supply cord strain relief Attach power supply cord to strain reliefElectrical Connection Choose electrical connection typeConnect neutral ground wire and neutral wire Connect ground wirePrepare to connect neutral ground wire and neutral wire Connect remaining wiresConnect neutral wire Attach direct wire strain reliefDirect Wire Strain Relief Remove center screwWire Direct Wire Connection Prepare your 4-wire cable for direct connectionIf your wiring looks like this Prepare your 3-wire cable for direct connection Optional 3-wire ConnectionVenting Connect external ground wireRigid metal vent Plan Vent System Whirlpool Vent System Chart Alternate installations for close clearancesSpecial provisions for mobile homes Determine vent pathInstall Vent System Connect Inlet HosesAttach long hose to Y connector and tighten couplings Attach long hose to dryer fill valve and tighten couplingTurn on cold water faucet Check for leaksAdjust leveling legs Connect VentLevel Dryer Move dryer to final locationComplete Installation Checklist Remove the door assemblyReverse Door Swing Steam models onlyReinstall the door Reverse the strike2013 05/13 All rights reserved