CONNECT VENT
1. Connect vent to exhaust outlet
Using a 4" (102 mm) clamp, connect vent to exhaust outlet in dryer. If connecting to existing vent, make sure vent is clean. Dryer vent must fit over dryer exhaust outlet and inside exhaust hood. Check that vent is secured to exhaust hood with a 4" (102 mm) clamp.
2. Move dryer to final location
Move dryer to final location. Avoid crushing or kinking vent. After dryer is in place, remove cardboard from under dryer.
LEVEL DRYER
1. Level Dryer
Place
level here
Place
level here
Check levelness of dryer from side to side. Repeat from front to back.
NOTE: The dryer must be level for the moisture sensing system to operate correctly.
Not Level | LEVEL | Not Level | |
2. | Adjust leveling legs |
| |
|
|
| Models |
|
|
| with riser |
|
|
| Models |
|
|
| without riser |
If dryer is not level, prop up using a wood block, use wrench
to adjust legs by backing out the foot as needed, then checking again for levelness. Once legs are level, make sure all four legs are snug against the floor.
17