Maytag W10131619A installation instructions Cleaning the Dryer Interior, Removing Accumulated Lint

Page 20

3.Wet a nylon brush with hot water and liquid detergent. Scrub lint screen with the brush to remove residue buildup.

4.Rinse screen with hot water.

5.Thoroughly dry lint screen with a clean towel. Replace screen in dryer.

Cleaning the Dryer Interior

1.Apply a liquid, nonflammable household cleaner to the stained area of the drum and rub with a soft cloth until stain is removed.

2.Wipe drum thoroughly with a damp cloth.

3.Tumble a load of clean cloths or towels to dry the drum.

NOTE: Garments that contain unstable dyes, such as denim blue jeans or brightly colored cotton items, may discolor the dryer interior. These stains are not harmful to your dryer and will not stain future loads of clothes. Dry unstable dye items inside-out to avoid transfer of dye.

Removing Accumulated Lint

From Inside the Dryer Cabinet

Lint should be removed every 2 years, or more often, depending on dryer usage. Cleaning should be done by a qualified person.

From the Exhaust Vent

Lint should be removed every 2 years, or more often, depending on dryer usage.

Vacation and Moving Care

Vacation care

Operate your dryer only when you are at home. If you will be on vacation or not using your dryer for an extended period of time, you should:

1.Unplug dryer or disconnect power.

2.Clean lint screen. See “Cleaning the Lint Screen.”

Moving care

For power supply cord-connected dryers:

1.Unplug the power supply cord.

2.Make sure leveling legs are secure in dryer base.

3.Use masking tape to secure dryer door.

For direct-wired dryers:

WARNING

Electrical Shock Hazard

Disconnect power before servicing.

Replace all parts and panels before operating.

Failure to do so can result in death or electrical shock.

1.Disconnect power.

2.Disconnect wiring.

3.Make sure leveling legs are secure in dryer base.

4.Use masking tape to secure dryer door.

20

Image 20
Contents Electric Dryer W10131619ATable of Contents Dryer SafetyImportant Safety Instructions Location Requirements Installation InstructionsTools and Parts Mobile Home Additional Installation Requirements Electrical RequirementsIt is your responsibility Electrical ConnectionIf using a power supply cord If connecting by direct wireGauge solid copper wire do not use aluminum If your outlet looks like thisPower Supply Cord Direct Wire Style 1 Power supply cord strain reliefInstall strain relief Electrical ConnectionStyle 2 Direct wire strain relief Wire connection Power Supply Cord Wire connection Direct Wire CG F Loosen or remove center silver-colored terminal block screwOptional 3-wire connection Tighten strain relief screwIf this is a new vent system Vent material If using an existing vent systemVenting Requirements Plan Vent System ExhaustRecommended hood styles are shown here Angled hood style shown here is acceptableInstall Vent System Alternate installations for close clearancesSpecial provisions for mobile home installations Vent system chartInstall Leveling Legs Connect VentLevel Dryer Reverse Door Swing OptionalComplete Installation If the dryer will not start, check the followingDryer USE Starting Your DryerHow Automatic Drying Works Stopping and RestartingCleaning the Dryer Location Cleaning the Lint ScreenDryer Care Drying Rack OptionVacation and Moving Care Cleaning the Dryer InteriorRemoving Accumulated Lint Dryer Results TroubleshootingDryer Operation Lint on load Stains on load or drumLoads are wrinkled Cycle time too shortAssistance or Service AccessoriesEnhance your dryer with these premium accessories Part Number AccessoryW10131619A