Installing the RPV-C 9953 and 9963 Hopper Loader Control
Use this control configuration to convert an existing 9953 or 9963 hopper loader into a proportioning hopper loader. The circuit board within these hopper loaders contains the circuitry necessary to control a Remote Proportioning Valve.
Wire the solenoids in the Remote Proportioning Valve as shown in Figure 7. Use #18AWG wire for the solenoid connections.
If your RPV has the
1.Connect Solenoid 1, Material A to Terminal 7 on 2TB.
2.Connect Solenoid 2, Material B to Terminal 8 on 2TB.
3.Wire the solenoid common wires to Terminal 10 on 2TB.
Figure 7: RPV-C to 9953 or 9963 Connection Diagram
Remote Proportioning Valve | Chapter 4: Installation | 20 of 30 |