Humminbird 67 System Status, Self Test Accessory Test GPS Diagnostic View, Accessory Test Screen

Page 38

System Status

Use System Status to view system connections and to conduct a unit self-test. Exit System Status by powering your Matrix Fishing System off.

The following screens are displayed in turn when you press the VIEW button when using System Status:

•Self Test

•Accessory Test

•GPS Diagnostic View.

Self Test displays results from the internal diagnostic self test, including unit serial number, Printed Circuit Board (PCB) serial number, software revision, total hours of operation and the input voltage.

System Status Self Test Screen

Accessory Test lists the accessories connected to the system.

NOTE: The speed accessory will be detected only if the paddlewheel has moved since your Matrix Fishing System was powered up.

Accessory Test Screen

GPS Diagnostic View shows a sky chart and numerical data from the GPS receiver. The sky chart shows the location of each visible GPS satellite with its satellite number and a signal strength bar. A dark grey bar indicates that the satellite is being used to determine your current position. A light gray bar indicates that the satellite is being monitored, but is not yet being used.

NOTE: The GPS Diagnostic View only appears if the GPS Receiver is connected.

32

Image 38

Contents Matrix 67GPS Trackplotter Operations Manual Thank You Table of Contents Sonar Menu Tab Sonar X-Press Menu Sonar Views OnlyNavigation X-Press Menu Navigation Views Only Navigation Menu Tab Alarms Menu TabSetup Menu Tab Accessories Menu Tab Troubleshooting QuadraBeam Sonar How Sonar WorksDualBeam Plus Sonar With Optional-Purchase WideSide Transducer WideSide SonarHow GPS and Cartography Work Multi-Media Card MMC Detailed MapWhat’s On the Sonar Display Bait Ball Hard Bottom Rocky Bottom83 kHz, Wide Beam Hollow Fish Symbol To your boat, including the following itemsSonar View ViewsSonar views Zoom ViewSonar View Sonar ViewUnderstanding Sonar History Real Time Sonar RTS WindowBottom Presentation Bottom Contour Profile with RTS WindowPage Sonar Zoom View Sonar Zoom View200/83 kHz Split Sonar View 200/83 kHz Split Sonar ViewBig Digits View Big Digits ViewSide Beam View Side Beam ViewWideSide View WideSide ViewBird’s Eye View Bird’s Eye ViewChart View Chart View with Active CursorViewing Cartography Combo ViewView Orientation Combo ViewPage Waypoints, Routes and Tracks Introduction to NavigationWaypoints, Routes and Tracks Save, Edit, or Delete a Waypoint Navigate to a Waypoint or Position Chart View with Grid Add a Waypoint Target or Trolling GridSave, Edit or Delete a Route Save or Clear a Current Track Edit, Delete or Hide Saved TracksView Key POWER/LIGHT KeyKey Functions Info KeyMark Key Menu KeyWAY Cursor Control Key Exit Key Goto KeyZoom +/- Key Matrix 67 Title Screen Accessory BusPowering Up the Unit Main Menu System Normal User Mode Menu SystemSonar Tab, Normal Mode Sonar Tab, Advanced Mode Simulator Start-Up Options MenuNormal Operation System Status Self Test Accessory Test GPS Diagnostic ViewAccessory Test Screen System Status Self Test ScreenWith PC Connect Cable Only GPS Diagnostic ViewPC Connect Sonar Views Only To adjust the WideSide ViewSonar X-PressTMMenu Sonar X-PressTMMenuHighlight Sensitivity on the Sonar X-PressTMmenu To adjust the SensitivitySensitivity Sensitivity at Low Sensitivity at MediumTo adjust the Upper Range Upper RangeHighlight Lower Range on the Sonar X-PressTMmenu To adjust the Lower RangeLower Range To adjust the Chart Speed Chart SpeedTo adjust the Side Beam Range Highlight Chart Speed on the Sonar X-Press menuBottom View To adjust the Bottom ViewTo adjust the Zoom Level Zoom LevelClear Current Track Navigation X-PressTMMenuSave Current Track Skip Next Waypoint Cancel NavigationSave Current Route Sonar Window Remove TargetRemove Grid Sonar Menu Tab Sonar MenuHighlight Beam Select on the Sonar main menu Beam SelectTo use Beam Select Transducer Cone and Fish Arches Fish ID+TMTo turn Fish ID+TM on or off Fish Sensitivity KHz SensitivityKHz Balance WideSide SensitivityDepth Lines To change the Depth Lines settingDepth Lines Surface Clutter To change the Surface Clutter settingSurface Clutter Noise Filter To change the Noise Filter settingTo change the Max Depth setting Max DepthTransducer Select To change the Water Type settingWater Type To change the selected TransducerNavigation Menu Tab To view the Tracks Submenu TracksTracks allows you to view the Tracks submenu Highlight Tracks on the Navigation main menuHighlight Waypoints on the Navigation main menu WaypointsTo view the Waypoints Submenu Waypoints Submenu contains the following menu choicesTo view the Routes Submenu To change the View Orientation settingRoutes Routes Submenu contains the following menu choicesTo change the Map Borders setting Chart Detail LevelTo change the Chart Detail Level setting Map BordersNorth Reference Lat/Lon GridSpot Soundings Grid RotationTrackpoint Interval To change the Trackpoint Interval settingTo change the Track Minimum Distance setting Track Min DistanceSet Map Offset Map DatumSet Simulation Position To Clear Map Offset Clear Map OffsetDelete All Nav Data To Delete All Navigation DataAlarms Menu Alarms Menu TabFrom any view, press the Menu key twice to access the Main To change the Depth Alarm setting Depth AlarmFish ID Alarm To change the Fish ID Alarm settingTo change the Low Battery Alarm setting Low Battery AlarmOff Course Alarm Highlight Low Battery Alarm on the Alarms main menuAlarm Tone Arrival AlarmDrift Alarm Setup Menu Tab Setup Menu TabUnits Distance Units DepthUnits Temp Language User ModeUnits Speed To Reset Triplog Triplog ResetRestore Defaults To Restore DefaultsSelect Views Select ViewsTo Select Views To Select Readouts Select ReadoutsAdvanced, Sonar View Only Speed Calibration Depth OffsetTemp Offset Position Format Local Time ZoneDaylight Savings Time Advanced, International Only Time FormatDate Format To change the Time FormatFollowing Nmea sentences are output Nmea OutputSonar To turn Nmea Output on or offAccessories Menu Tab Accessories Menu TabTroubleshooting Fishing System Doesn’t Power UpDisplay Problems Problem Possible CauseFinding the Cause of Noise Possible Source of Noise IsolationMatrix Fishing System Accessories Specifications Page Custserv@techsonic.com Monday Friday 800 a.m. to 430 p.m. Central Standard Time