Humminbird 595C manual Sonar X-Press Menu, Sonar Views Only, Position Error, GPS Diagnostic View

Page 19

FF595_Man_531385-1_A_PrfE.qxd 12/9/2004 2:40 PM Page 36

GPS Diagnostic View shows a sky chart and numerical data from the GPS receiver. The sky chart shows the location of each visible GPS satellite with its satellite number and a signal strength bar. A dark grey bar indicates that the satellite is being used to determine your current position. A light gray bar indicates that the satellite is being monitored, but is not yet being used.

NOTE: The GPS Diagnostic View only appears if the GPS Receiver is connected.

This view also reports the current position, local time and date, and other numeric information. The current GPS Fix Type is reported as No Fix, 2D Fix, 3D Fix, or Enhanced. An Enhanced fix has been augmented using information from WAAS, EGNOS, or MSAS. A 3D or Enhanced Fix is

required for navigation. HDOP (the Horizontal Dilution of Precision) is a GPS system parameterSonar X-Press™ Menu which depends on the current satellite configuration. HDOP is used to calculate the Estimated

Position Error.

GPS Diagnostic View

Sky Chart

Satellite

Being Used

Satellite Being

Monitored

Current Latitude

and Longitude

Sonar X-Press™ Menu

(Sonar Views Only)

The Sonar X-Press™ Menu provides access to the settings most frequently-used. Press the MENU key once while in any of the Sonar Views to access the Sonar X-Press™ Menu.

NOTE: Menu choices will vary depending on system settings such as whether the unit is set for Advanced User mode or what transducer is currently selected.

30

31

Image 19

Contents FishFinder 595c Operations Manual Thank You Table of ContentsSonar X-Press Menu Sonar Views Only Powering Up the Unit Menu System Start-Up Options MenuAlarms Menu Tab Setup Menu TabHow Sonar Works Views Menu Tab TroubleshootingSingle Beam Sonar Multi-Media Card MMC How GPS and Cartography WorkRTS Real Time Sonar Window Low Sonar Intensity Return KHz Fish SymbolWhat’s On the Sonar Display High Sonar Intensity Return Bait BallSonar views Sonar Zoom View Chart View Big Digits ViewViews Sonar ViewReal Time Sonar RTS Window Understanding Sonar HistoryBottom Presentation Big Digits View Sonar Zoom ViewBig Digits View Bird’s Eye View Chart ViewChart View with Active Cursor Bird’s Eye ViewView Orientation Combo ViewViewing Cartography Waypoints, Routes and Tracks Introduction to NavigationWaypoints, Routes and Tracks Save, Edit, or Delete a WaypointAdd a Waypoint Target or Trolling Grid Chart View with TargetNavigate to a Waypoint or Position Save, Edit or Delete a Route Chart View with GridSave or Clear a Current Track View Key POWER/LIGHT KeyEdit, Delete or Hide Saved Tracks Key FunctionsZoom +/- Key WAY Cursor Control KeyMark Key Goto KeyMenu System Powering Up the UnitMain Menu System Normal User Mode Sonar Tab, Normal Mode Sonar Tab, Advanced ModeSystem Status Start-Up Options MenuNormal Operation SimulatorSonar Views Only Position ErrorGPS Diagnostic View Sonar X-Press MenuUpper Range To adjust the SensitivityTo adjust the Upper Range SensitivityLower Range Chart SpeedBottom View Save Current Route Navigation X-Press MenuSave Current Track Clear Current TrackRemove Grid Cancel NavigationSkip Next Waypoint Remove TargetFish ID+ Sonar Menu TabTo turn Fish ID+ on or off Depth Lines Fish SensitivityAdvanced Water Type Surface ClutterNoise Filter Max DepthTracks Submenu contains the following menu choices Navigation Menu TabTracks WaypointsRoutes Chart Detail LevelMap Borders North Reference Lat/Lon GridSpot Soundings Shaded DepthClear Map Offset Map DatumSet Simulation Position Set Map OffsetLow Battery Alarm Alarms Menu TabDepth Alarm Fish ID AlarmDrift Alarm Temp AlarmOff Course Alarm Arrival AlarmSetup tab is selected Alarm ToneSetup Menu Tab To change the Alarm Tone settingUnits Temp User ModeUnits Depth Units SpeedAdvanced, Sonar View Only Triplog ResetRestore Defaults Select ReadoutsLocal Time Zone Depth OffsetTemp Offset Speed CalibrationSonar Time FormatDate Format Nmea OutputViews Menu Tab TroubleshootingFishFinder Doesn’t Power Up FishFinder Defaults to Simulator with a Transducer AttachedIsolation Display ProblemsProblem Possible Cause Finding the Cause of NoiseSpecifications Humminbird FishFinder AccessoriesContact Humminbird