3M eg4 user manual Customizing set-up parameters in DMS, New Hardware wizard for Edge Dock

23

Docking Customizing set-up parameters in DMS

Communicating & downloading data

4.For first time use of a docking station, Welcome to the found new hardware wizard will appear (see Figure 2-8). Select No and press Next through the remaining wizard. At the end of the wizard, press Finish.

•This will install the hardware components associated with your EdgeDock1 and/or EdgeDock5.

NOTE: If you have more than one EdgeDock1 or EdgeDock5, this wizard will appear for each new dock which is connected to your pc.

Figure 3-5: New Hardware wizard for Edge Dock

Customizing set-up parameters in DMS

Customizing and saving set-ups are performed via DMS. The following sections discuss each of the setup screens and explain how to save and send the parameters to the dosimeter(s).

NOTE: The following DMS settings apply to the eg4 model. If you are also using other models such as the eg3/eg4 and have them docked in a 5-bay charger, they will appear in the “Edge Bay Charger” tree section. If you are also using other models (eg5) and have them docked in

a 5-bay charger, they will appear in the “Edge Bay Charger” tree section with a icon. To select Edge 5 models, first select the Model (on the left-hand panel) and then click the refresh button. The instruments are selected by clicking in the checkbox(es).

Example of EdgeDock-5 with Edge 4 selected in the first bay.

053-644, Rev H Page 23 eg4