3M eg4 user manual Hard Hat Attachment Kit, Hard Hat Attachment kit

48

Technical Support

Hard Hat Attachment Kit

Hard Hat Attachment Kit

The following instructions explain how to assemble and attach the hard hat kit to a standard hard hat.

A B

Hard Hat Attachment kit

A.Epaulette mount

B.Hard hat mount

1.Using a 3/32” hex wrench, twist the top shoulder bolt counterclockwise to loosen and remove the bolt and the clip. Also, remove the bottom clip with the hex wrench. Once the bottom clip is removed, place the shoulder bolt back into its place and tighten back up with the hex wrench.

Shoulder bolt

Hex wrench

2.Place the epaulette mount (see “A” above) into the top bracket of the Edge. Then slide the bolt into place and tighten with a hex wrench. Then, the epaulette mount snaps onto the bottom shoulder bolt.

Shoulder bolt

Epaulette

3.Slide the two prongs of the hard hat mount (see “B” above) underneath the epaulette mount (see “A above) until it clicks into place.

Hard hat mount attachment (The two prongs slide into the bottom cavity.)

4.Taking the Edge with the assembled hard hat attachments, slide into the side of hard hat. It will fit snuggly into the hard hat opening.

Slide the two-sided prongs into the hard-hat opening.

053-644, Rev H Page 48 eg4