3M eg4 user manual Running studies, Starting a run,  How to run a noise study

37

Running studies

Starting a run

Running studies

With a couple pushes on the keypad buttons, you will be running and viewing your study (ies). Following your study (ies), you can load the data/files into DMS to manipulate, analyze, save, and create reports (See Chapter 5 for viewing your logged data in DMS).

Starting a run

How to run a noise study

1. If your dosimeter is turned off, press the on/off enter button to power on.

2. Press and hold the run/stop button.

•A 3, 2, 1 countdown will appear.

3.When running, the following will appear:

•A run indicator will appear on the top-right side.

•The LED indicator will flash green (unless you disabled this in DMS.)

Measurements

•Use up/down arrow to move through values.

•Views are customizable via DMS setup

Flashing green LED indicates running

Battery indicator

Run indicator Appears when running

Figure 4-8: Display screen while running

053-644, Rev H Page 37 eg4