Raymarine D7637-1 manual Zigzag, How do I follow a zig-zag pattern?

Page 15

How do I follow a zig-zag pattern?

When you enter ZIGZAG mode, the autopilot will use your current position and heading as the center line of the zig-zag. The autopilot will now gently steer your boat into the pattern starting with a turn to starboard.

press repeatedly until

MODE

you reach ZIGZAG

change pattern size (Sml, Med or Large)

activates autopilot

PILOT

in ZIG ZAG mode

1 2 3

From any screen:

1.Press MODE repeatedly until ZIGZAG is displayed.

2.Use the PORT and STARBOARD keys to change the size (S, M or L) if required

3.Press the PILOT key to activate the autopilot

ZIGZAG

Quick Tip

Fishing patterns are designed to work at speeds up to 15kts. Check your speed before starting.

D7621-1

User Guide	11

Image 15

Contents Raymarine S1000 Autopilot Page Alarms and Troubleshooting Contents Getting StartedUsing your S1000 Setting up your S1000Important Information Getting started Changing the Controller batteries System ComponentsNavigate Starboard S100 Autopilot ControllerOperation modes How do I power the system on?Using fishing patterns Power saving modePerformance check Wireless signal strengthGPS filtering KeylockUsing your S1000 System How do I use the autopilot? How do I automatically steer straight? AutoMode How do I follow a route from my GPS?How do I follow a circle pattern? CircleHow do I follow a zig-zag pattern? ZigzagHow do I follow a cloverleaf pattern? CloverleafHow do I dodge an obstacle? Setting up How do I change the pattern direction? You can change the default autopilot pattern directionHow do I change my boat type? Press and hold ModePress mode until the display reads Setup How do I adjust the autopilot settings?What is Rudder Gain? What is Counter Rudder? What is Auto Trim? What is Response?User Guide Alarms and Troubleshooting Alarm Message S1000 Alarm messagesNo GPS FIX Symptom Fault findingFrequently-asked questions Safety alarmGeneral maintenance Cleaning the S1000 and S100Routine checks Dealer Maintenance Procedures Factory Reset To Register a handsetTo de-register a handset Product support User Guide Important Safety Information Safety Notices In-line power switchProduct installation Raymarine S1000 Autopilot FCC Information General Care and SafetyRadio frequency energy Exposure to radio frequency energyWaste Electrical and Electronic Equipment Directive Intended UseDeclaration of Conformity DisposalEMC Guidelines Handbook InformationConnections to other equipment