Raymarine D7637-1 manual Fault finding, Symptom

Page 29

Fault finding

All Raymarine products are designed to provide many years of trouble-free operation. We also put them through comprehensive testing and quality assurance procedures before shipping.

If a fault occurs with your S1000, use the fault finding tables in this section to help identify the problem and provide a solution. If you cannot resolve the problem yourself, refer to the product support information.

SYMPTOM

POSSIBLE CAUSE and SOLUTION

 

 

Display is blank

No power – press standby to power up the S100

 

or change the batteries.

 

 

Autopilot not responding.

Drive the boat for 30 seconds at above 2.5kts and

 

retry.

 

Check autopilot connections.

 

Check GPS is switched on and connected.

 

 

Boat turns slowly and takes a

Rudder gain too low. Increase gain setting.

long time to come onto course

 

 

 

Boat overshoots when turning

Rudder gain too high. Decrease gain setting.

onto a new course

 

 

 

Position information not

Navigator not transmitting the correct position

received

data.

 

 

The pilot will not auto advance

No bearing to waypoint information received from

to the next waypoint.

the navigator.

 

 

Instruments powered from

Check connections

SeaTalk will not power up

Check fuses

 

 

User Guide

25

 

 

Image 29
Contents Raymarine S1000 Autopilot Page Using your S1000 Contents Getting StartedSetting up your S1000 Alarms and TroubleshootingImportant Information Getting started Changing the Controller batteries System ComponentsNavigate Starboard S100 Autopilot ControllerUsing fishing patterns How do I power the system on?Power saving mode Operation modesGPS filtering Wireless signal strengthKeylock Performance checkUsing your S1000 System How do I use the autopilot? How do I automatically steer straight? AutoMode How do I follow a route from my GPS?How do I follow a circle pattern? CircleHow do I follow a zig-zag pattern? ZigzagHow do I follow a cloverleaf pattern? CloverleafHow do I dodge an obstacle? Setting up How do I change the pattern direction? You can change the default autopilot pattern directionHow do I change my boat type? Press and hold ModePress mode until the display reads Setup How do I adjust the autopilot settings?What is Rudder Gain? What is Counter Rudder? What is Auto Trim? What is Response?User Guide Alarms and Troubleshooting Alarm Message S1000 Alarm messagesNo GPS FIX Symptom Fault findingFrequently-asked questions Safety alarmRoutine checks General maintenanceCleaning the S1000 and S100 Dealer Maintenance Procedures To de-register a handset Factory ResetTo Register a handset Product support User Guide Important Safety Information Product installation Safety NoticesIn-line power switch Raymarine S1000 Autopilot Radio frequency energy General Care and SafetyExposure to radio frequency energy FCC InformationDeclaration of Conformity Intended UseDisposal Waste Electrical and Electronic Equipment DirectiveConnections to other equipment EMC GuidelinesHandbook Information