Raymarine D7637-1 manual No GPS FIX

Page 28

ALARM MESSAGE

POSSIBLE CAUSE and SOLUTION

 

 

NO GPS COG

The S1000 autopilot is not receiving valid COG data

 

from your GPS system. Check the connections and

 

that your GPS unit is powered on and setup to

 

transmit COG data.

 

 

NO GPS FIX

Your GPS is receiving a low strength signal, this will

 

clear when the signal improves

 

 

NO PILOT

The controller is not receiving data from the autopi-

 

lot. Check connections and that the S1000 course

 

computer is switched on.

 

 

OFFCOURSE

This alarm sounds if you have been off course from

 

the locked heading for more than 20 seconds. It

 

also states if you are to the PORT or STARBOARD of

 

the intended heading.

 

 

REGISTRATION INCOMPLETE

The registration of your new handset cannot be

 

completed as the system has detected other hand-

 

sets in the vicinity.

 

1. Switch off all other remote handheld units. and

 

repeat the registration process.

 

2. If this error persists, take your boat to open water

 

(with no other vessel within 100 ft) and repeat the

 

registration process.

 

 

ROUTE COMPLETE

This sounds on the completion of a track. Press

 

PILOT to continue on the same heading or

 

STANDBY for manual control.

 

 

SHIPS BATTERY

The ships battery voltage has dropped below

 

acceptable limits, check the charge state of the bat-

 

tery.

 

 

TOO SLOW

Your speed has fallen below 1 knot. You must be

 

travelling faster for the pilot to operate

 

 

TOO FAST TO FISH

Fishing patterns will only operate at speeds below

 

15kts. Check your speed.

 

 

WAYPOINT ADVANCE

You have arrived at a waypoint on your route. The

 

autopilot is now requesting permission to turn onto

 

the next leg, press PILOT to accept.

 

 

24

Raymarine S1000 Autopilot

 

 

Image 28
Contents Raymarine S1000 Autopilot Page Contents Getting Started Using your S1000Setting up your S1000 Alarms and TroubleshootingImportant Information Getting started System Components Changing the Controller batteriesS100 Autopilot Controller Navigate StarboardHow do I power the system on? Using fishing patternsPower saving mode Operation modesWireless signal strength GPS filteringKeylock Performance checkUsing your S1000 System How do I use the autopilot? Auto How do I automatically steer straight?How do I follow a route from my GPS? ModeCircle How do I follow a circle pattern?Zigzag How do I follow a zig-zag pattern?Cloverleaf How do I follow a cloverleaf pattern?How do I dodge an obstacle? Setting up You can change the default autopilot pattern direction How do I change the pattern direction?Press and hold Mode How do I change my boat type?How do I adjust the autopilot settings? Press mode until the display reads SetupWhat is Rudder Gain? What is Counter Rudder? What is Response? What is Auto Trim? User Guide Alarms and Troubleshooting S1000 Alarm messages Alarm MessageNo GPS FIX Fault finding SymptomSafety alarm Frequently-asked questionsCleaning the S1000 and S100 General maintenanceRoutine checks Dealer Maintenance Procedures To Register a handset Factory ResetTo de-register a handset Product support User Guide Important Safety Information In-line power switch Safety NoticesProduct installation Raymarine S1000 Autopilot General Care and Safety Radio frequency energyExposure to radio frequency energy FCC InformationIntended Use Declaration of ConformityDisposal Waste Electrical and Electronic Equipment DirectiveHandbook Information EMC GuidelinesConnections to other equipment