Raymarine D7637-1 manual How do I power the system on?, Operation modes, Using fishing patterns

Page 8

How do I power the system on?

POWER ON

Ensure that the S1000 and GPS is powered on at the vessel’s breaker. On the controller, press and hold the STANDBY button. The handset will beep, the display will read STANDBY and you’re ready to go.

When you first switch the S1000 on, it is normal to experience a delay of about 80 seconds while the processor stabilizes. This delay also occurs when you restart following an emergency power-off.

When trolling at slow speeds, the autopilot may take up to 50 seconds to acquire stable GPS signals and engage AUTO (this is typical of GPS signals at this slow speed). If you try to engage AUTO during this period, the S100 will display the message "INITIALISING".

Operation modes

The S100 wireless controller is automatically set to Fishing Mode. Do not select Sail or Power mode as this will cause a loss of calibration.

Using fishing patterns

A short period of operation in AUTO mode is required before accessing fishing patterns. This allows the course computer to stabilise using the incoming GPS information. Fishing patterns are only available from AUTO mode (not STANDBY).

Power saving mode

If you are in STANDBY mode (autopilot off), the handset will automatically turn off if no button has been pressed for 5 minutes. This will help to extend the battery life.

4	Raymarine S1000 Autopilot

Image 8

Contents Raymarine S1000 Autopilot Page Contents Getting Started Using your S1000Setting up your S1000 Alarms and TroubleshootingImportant Information Getting started System Components Changing the Controller batteriesS100 Autopilot Controller Navigate StarboardHow do I power the system on? Using fishing patternsPower saving mode Operation modesWireless signal strength GPS filteringKeylock Performance checkUsing your S1000 System How do I use the autopilot? Auto How do I automatically steer straight?How do I follow a route from my GPS? ModeCircle How do I follow a circle pattern?Zigzag How do I follow a zig-zag pattern?Cloverleaf How do I follow a cloverleaf pattern?How do I dodge an obstacle? Setting up You can change the default autopilot pattern direction How do I change the pattern direction?Press and hold Mode How do I change my boat type?How do I adjust the autopilot settings? Press mode until the display reads SetupWhat is Rudder Gain? What is Counter Rudder? What is Response? What is Auto Trim?User Guide Alarms and Troubleshooting S1000 Alarm messages Alarm MessageNo GPS FIX Fault finding SymptomSafety alarm Frequently-asked questionsRoutine checks General maintenanceCleaning the S1000 and S100 Dealer Maintenance Procedures To de-register a handset Factory ResetTo Register a handset Product support User Guide Important Safety Information Product installation Safety NoticesIn-line power switch Raymarine S1000 Autopilot General Care and Safety Radio frequency energyExposure to radio frequency energy FCC InformationIntended Use Declaration of ConformityDisposal Waste Electrical and Electronic Equipment DirectiveConnections to other equipment EMC GuidelinesHandbook Information