Raymarine D7637-1 manual General maintenance, Routine checks, Cleaning the S1000 and S100

Page 31

Q. What should I do when the safety alarm sounds?

The safety alarm will sound when the pilot switches to STANDBY as a safety precaution.You MUST take the helm.

The safety alarm will sound when the pilot is in control of your boat, and:

•the S1000 loses contact with all of its connected controllers or

•when the S1000 stops receiving valid GPS information.

General maintenance

Routine checks

The S1000 computer and S100 controller do NOT contain user-serviceable parts. If you remove the main cover you will invalidate the warranty. It should be serviced only by authorized Raymarine service technician.

As a result, user maintenance is limited to the following checks

•make sure all cable connectors are firmly attached and free of corrosion

•examine for signs of wear or damage – replace any damaged cables

•replace batteries when necessary

Cleaning the S1000 and S100

Take care when cleaning the display. Avoid wiping the display screen with a dry cloth as this could scratch the screen coating. If necessary, only use a mild detergent.

Never use chemical or abrasive materials to clean the computer or controller. If it is dirty, wipe it with a clean, damp cloth.

User Guide	27

Image 31

Contents Raymarine S1000 Autopilot Page Alarms and Troubleshooting Contents Getting StartedUsing your S1000 Setting up your S1000Important Information Getting started Changing the Controller batteries System ComponentsNavigate Starboard S100 Autopilot ControllerOperation modes How do I power the system on?Using fishing patterns Power saving modePerformance check Wireless signal strengthGPS filtering KeylockUsing your S1000 System How do I use the autopilot? How do I automatically steer straight? AutoMode How do I follow a route from my GPS?How do I follow a circle pattern? CircleHow do I follow a zig-zag pattern? ZigzagHow do I follow a cloverleaf pattern? CloverleafHow do I dodge an obstacle? Setting up How do I change the pattern direction? You can change the default autopilot pattern directionHow do I change my boat type? Press and hold ModePress mode until the display reads Setup How do I adjust the autopilot settings?What is Rudder Gain? What is Counter Rudder? What is Auto Trim? What is Response?User Guide Alarms and Troubleshooting Alarm Message S1000 Alarm messagesNo GPS FIX Symptom Fault findingFrequently-asked questions Safety alarmCleaning the S1000 and S100 General maintenanceRoutine checks Dealer Maintenance Procedures To Register a handset Factory ResetTo de-register a handset Product support User Guide Important Safety Information In-line power switch Safety NoticesProduct installation Raymarine S1000 Autopilot FCC Information General Care and SafetyRadio frequency energy Exposure to radio frequency energyWaste Electrical and Electronic Equipment Directive Intended UseDeclaration of Conformity DisposalHandbook Information EMC GuidelinesConnections to other equipment