Raymarine D7637-1 manual Cloverleaf, How do I follow a cloverleaf pattern?

Page 16

How do I follow a cloverleaf pattern?

When you enter CLOVERLEAF mode, the autopilot will use your current position as the center point. The autopilot will then steer your boat through a series of starboard turns, repeatedly intersecting the start point.

MODE

press repeatedly until you reach CLOVERLEAF

change pattern size (Sml, Med or Large)

1 2 3

From any screen:

1.	Press MODE repeatedly until
	CLOVERLEAF is displayed.
2.	Use the PORT and
	STARBOARD keys to change
	the size (S, M or L) if required

PILOT

activates autopilot

in CLOVERLEAF mode

3. Press the PILOT key to activate

the autopilot

CLOVERLEAF

	Quick Tip	You can change the pattern direction in
	Quick Tip	PILOT SETUP (See section 3)
		PILOT SETUP (See section 3)

D7622-1

12	Raymarine S1000 Autopilot

Image 16

Contents Raymarine S1000 Autopilot Page Contents Getting Started Using your S1000Setting up your S1000 Alarms and TroubleshootingImportant Information Getting started System Components Changing the Controller batteriesS100 Autopilot Controller Navigate StarboardHow do I power the system on? Using fishing patternsPower saving mode Operation modesWireless signal strength GPS filteringKeylock Performance checkUsing your S1000 System How do I use the autopilot? Auto How do I automatically steer straight?How do I follow a route from my GPS? ModeCircle How do I follow a circle pattern?Zigzag How do I follow a zig-zag pattern?Cloverleaf How do I follow a cloverleaf pattern?How do I dodge an obstacle? Setting up You can change the default autopilot pattern direction How do I change the pattern direction?Press and hold Mode How do I change my boat type?How do I adjust the autopilot settings? Press mode until the display reads SetupWhat is Rudder Gain? What is Counter Rudder? What is Response? What is Auto Trim?User Guide Alarms and Troubleshooting S1000 Alarm messages Alarm MessageNo GPS FIX Fault finding SymptomSafety alarm Frequently-asked questionsCleaning the S1000 and S100 General maintenanceRoutine checks Dealer Maintenance Procedures To Register a handset Factory ResetTo de-register a handset Product support User Guide Important Safety Information In-line power switch Safety NoticesProduct installation Raymarine S1000 Autopilot General Care and Safety Radio frequency energyExposure to radio frequency energy FCC InformationIntended Use Declaration of ConformityDisposal Waste Electrical and Electronic Equipment DirectiveHandbook Information EMC GuidelinesConnections to other equipment