Raymarine D7637-1 manual Dealer Maintenance Procedures

Page 32

Dealer Maintenance Procedures

This section includes procedures that have a significant impact on autopilot operation and can affect your boat’s safety. You will not need to follow these procedures in normal operation. We therefore recommend that these are only performed by authorized service personnel.

Accessing the dealer calibration area.

From STANDBY mode, press and hold STANDBY for 2 seconds to enter PILOT SETUP. Then press and hold mode for 5 seconds until the dealer calibration screen is displayed.

Subsequent presses of mode will cycle through the calibration options.

Hardware and Software version numbers

Use this screen to display the version and serial numbers for the unit.

Contrast

Use the < and > keys to adjust the contrast to a satisfactory level.

Self test

Press PILOT to start the unit test sequence and then follow the on-screen instructions. This will test the display, buzzer and button functions.

Diagnostics

Press PILOT to display the status of the wireless link.

Handset Registration

Raymarine wireless systems demand that each wireless controller is “registered” to a basestation, in this case a S1000. This registration process is to prevent unauthorized control of your boat by another user nearby. Your S1000 system is supplied with the handset pre-registered to the S1000.

There may be instances where you want to move your controller to another boat and use it with another system. In this case, you will need to de-register from the current system and register with the new system. You can do this using the REGISTRATION function.

28

Raymarine S1000 Autopilot

 

 

Page 31 Page 33
Image 32
Page 31 Page 33
Contents Raymarine S1000 Autopilot Page Contents Getting Started Using your S1000Setting up your S1000 Alarms and TroubleshootingImportant Information Getting started System Components Changing the Controller batteriesS100 Autopilot Controller Navigate StarboardHow do I power the system on? Using fishing patternsPower saving mode Operation modesWireless signal strength GPS filteringKeylock Performance checkUsing your S1000 System How do I use the autopilot? Auto How do I automatically steer straight?How do I follow a route from my GPS? ModeCircle How do I follow a circle pattern?Zigzag How do I follow a zig-zag pattern?Cloverleaf How do I follow a cloverleaf pattern?How do I dodge an obstacle? Setting up You can change the default autopilot pattern direction How do I change the pattern direction?Press and hold Mode How do I change my boat type?How do I adjust the autopilot settings? Press mode until the display reads SetupWhat is Rudder Gain? What is Counter Rudder? What is Response? What is Auto Trim?User Guide Alarms and Troubleshooting S1000 Alarm messages Alarm MessageNo GPS FIX Fault finding SymptomSafety alarm Frequently-asked questionsRoutine checks General maintenanceCleaning the S1000 and S100 Dealer Maintenance Procedures To de-register a handset Factory ResetTo Register a handset Product support User Guide Important Safety Information Product installation Safety NoticesIn-line power switch Raymarine S1000 Autopilot General Care and Safety Radio frequency energyExposure to radio frequency energy FCC InformationIntended Use Declaration of ConformityDisposal Waste Electrical and Electronic Equipment DirectiveConnections to other equipment EMC GuidelinesHandbook Information
Top Page Image Contents