Primera Technology 061605-510800-(01) user manual Setup Ieee USB 2.0 / 1394 Firewire devices

Page 6

3.Temperature Warning:

If the duplicator was stored in a location where the temperature dropped below 32°F (0°C) within the past 24 hours, please leave the duplicator in a warm room with temperatures at least 65°F (19°C) for 4 hours prior to powering it on for the first time. Failure to do so may cause irreparable harm and prevent the duplicator from functioning.

4.External Connection Warning:

If you have an external connection installed in your duplicator, you will see the USB/Firewire sticker(s) on your writer front drive panel(s). In order to operate the duplicator solely as a standalone unit (no connection to the computer), you have to make sure all of the USB/Firewire connection(s) are off. If by any chance, the USB/Firewire connection(s) are on, please refer to “Setup Guide:

Setup IEEE USB 2.0 / 1394 Firewire device(s)”

5.Maintenance:

It is very important to operate and keep the duplicator in a dust free, clean environment since dust is the number 1 killer for CD/DVD recording devices. Failure to do so may severely damage your duplicator. We strongly suggest you place an Air Cleaner next to the duplicator and constantly use the Air Duster (Can Air) to clear off any dust on the surface of the duplicator.

Do not try to use the Air Duster to clean the duplicator while the reader/writer trays are open. In doing so, you may inadvertently blow dust into the recording device and damage the recording device.

6.Proper Shutdown:

To avoid possible system failures, you need to shutdown the duplicator properly. To shutdown the duplicator, you need to press “>>” button to “16. Shutdown” and follow instructions on the screen to shutdown the duplicator properly. Turning off your duplicator without performing this function will increase the risk of damaging

-2 -

Image 6

Contents USER’S Manual Table of Content Setup Title Welcome Before you startSetup Ieee USB 2.0 / 1394 Firewire devices Your duplicator LCD Front Panel Tutorial Guide Make Disc-to-Disc Copies Select SourceDrive 1 Port Pioneer DVD-ROM Introduction to Duplication Mode Go back to Copy MenuStart the Copy Process Counter No Counter Counter Specify CounterSpecify Counter OK? Specify Counter OK? Preparing Waiting for Master Waiting for Blanks Preparing Disc Detected, Go?Processing Please Wait Copying .. MB 21 12% 481MBCopying .. MB OR0 12% 481MB Pass 7 Fail Page How to make copies from the Hard Drive? Make sure the Master Reading Source is set to the Hard Drive Hard Drive PortHard Drive Setup Select Partition Hard Drive Setup Load PartitionLoad Partition 4 Load-New Partition Edit Partition Name Load Loading10% 423MB Load Partition OK Press OK to Continue Choose PartitionCounter Specify Counter Specify Counter OK? Preparing Waiting for Blanks Copying ... H4012MB 21 12% 481MB Copying ... H4012MB 12% 481MBPass 7 Fail Tutorial Guide III. Select the Duplication Speed Navigate to Speed Selection MenuSelect Duplication Speed Type Enter Speed Selection MenuSelect Burn Speed DVD to DVD Select Desired Duplication SpeedDVD to DVD Speed Adjusted to DVD to DVD SpeedTutorial Guide Select the Master Reading Source Navigate to Source Selection Menu Duplicator 1.00 8.Select SourceEnter Source Selection Menu Select Desired Master Reading Device Drive 1 Port SelectedTutorial Guide Load Master Disc onto the Hard Drive Hard Drive Port 0 WDC WD400EB-75CPF0 Load your master disc onto the Hard Drive Edit Partition Name FUN Loading Hard Drive Setup Rename Partition Tutorial Guide VI. Rename Existing Hard Drive Partition NameNow, you can rename the partition you’ve just selected Enter HDD Image Name FUNxThen, you will be directed back to Hard Drive Setup Menu Partition FUN2 RenamedHard Drive Setup Delete Partition Partition FUN Deleted Press to enter Setup Menu and you shall see the following Tutorial Guide VIII. Change the Setup settingsDuplicator 1.00 12.Setup Setup LanguaAuto Start Tutorial Guide IX. Audio CD Editing Going to the Edit Audio Track menu Edit Track To Blank CDOnce you made your selection, you shall see the following Preparing Waiting for Master Waiting for a BlankTotal 0 Trk 0m 0s Track 1 4m31s Total 6 Trk 26m17s Are you done? Audio EditingTotal 6 Trk 26m17s Finish Editing? Total 6 Trk 26m17s Insert Next Master? Total 6 Trk 26m17s Confirm to Finalize?Finalizing Please Wait Job Completed Press OK to Finish Total 2 Trk 9m47s Track 4 4m58s Total 0 Trk 0m00s Track 1 4m03sTotal 1 Trk 4m49s Track 2 4m49s Total 2 Trk 9m47s Are you done?Total 2 Trk 9m47s Track 1 4m03s Total 2 Trk 9m47s Finish Editing?Total 2 Trk 9m47s Insert Next Master? Total 3 Trk 14m35s Track 3 4m47sAudio Editing 4m47s Total 5 Trk 24m29s Track 5 4m27sTotal 5 Trk 24m29s Are you done? Total 5 Trk 24m29s Finish Editing?Job Completed Press OK to Finish Tutorial Guide Introduction to Account Management Feature Enter Admin’s PWD CopyManage Accounts Manage Accounts View User There are five menus in the Manage AccountsManage Accounts Create User Manage Accounts Edit User InfoManage Accounts Password on Bootup Manage Accounts Delete UserTutorial Guide XI. Introduction to Duplication Mode On the Fly Load and CopyPress UP or Down Button Consecutively until you see Tutorial Guide XII. Using Autocopy Duplicator 1.00 15.AutoCopy Copying .. MB 12% 481MBPass 7 Fail Setup Guide Setup USB 2.0 / Firewire devices If there’s a switch next to the USB/Firewire PortIf there is not a switch next to the USB/Firewire Port Menu Overview DriveHDD-to-Disc CopiesTest + Copy Language Auto StartRead Error Skip CD Writing ModeMax Audio, VCD & CDG Speed Buzzer Duplication ModeIntroduction to Duplication Mode Counter Startup MenuIsrc 12.11 DVD+R High Compatibility ModeDisable Drives Utility Disc InfoLoad Default System InfoDevice Info Save Update FirmwareUsing Autocopy Shutdown Account ManagementCopy completed but the copies are not readable / executable? Utility Failure rate is highUtility Load Default Load Default Press OK to continueUtility Disc Info Error Code Blank media you’ve inserted does not