LSI AP1172-E1 Domestic International AC Power, AC Plug, Receptacle, Circuit Breaker, Frequency

72-Inch Cabinet Site Preparation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Power Requirements

This section provides information regarding power requirements, AC power distribution box specifications, ladder cord and power cord routing instructions, and site wiring conditions.

The AC power source must provide the correct voltage, current, and frequency specified on the manufacturer’s nameplate. Table 1-3shows the internal AC power requirements for rackmount cabinets.

	Table 1-3		Power Requirements
Unit/Component			Requirements
	Domestic			International
AC Power	250 VAC, 30 A			230 VAC, 32 A
AC Plug	NEMA L6-30P, locking plug			IEC 309 locking plug
Receptacle	6-30R, receptacle			IEC 309 receptacle
Circuit Breaker			25 A
Voltage Range			180 to 257 VAC
Frequency			49 to 50.5 Hz or 59 to 60.6 Hz
Current			220 VAC, 50/60 Hz
(specified frequency)
		Configuration A1		Configuration B1	Configuration C1
Operational Current	LP Drives2		7.35 A	14.70 A	13.16 A
	HH Drives2		7.70 A	15.40 A	13.72 A
Surge Current	LP Drives		10.95 A	21.90 A	22.20 A
	HH Drives		11.45 A	22.90 A	23.00 A

1Power specifications for three configurations containing Low-Profile (LP) and Half-Height (HH) drives, including: Configuration A contains 1 command module and 5 drive modules

Configuration B contains 2 command modules and 10 drive modules Configuration C contains 3 command modules and 8 drive modules

2LP drives are 1.0 inch tall; HH drives are 1.6 inches tall.

1-8 Command Module and Drive Module Site Preparation Guide