Furuno FAR-2167DS-BB, FAR-2167DS-D installation manual Mounting the antenna unit

2.Lay the corrosion-proof rubber mat (supplied) on the mounting platform, aligning the holes on the rubber mat with the fixing holes on the mounting platform.

3.Lay the antenna unit on the rubber mat, orienting it so the cable gland is directed toward ship's bow. Remove the lifting fixtures and collars.

4.Fix the antenna base to the mounting platform with four M12×70 hex bolts, nuts, washers and seal washers (supplied).

5.Arrange the ground point at a location on the mounting platform that is within 300 mm from the ground terminal on the antenna unit. Fasten the ground wire (RW-4747, 340 mm) there, using the M6×25 hex bolt, nut and washers.

6.Connect the other end of the ground wire to the ground terminal on the antenna unit.

7.Coat the ground terminal, ground point on the mounting platform and fixing bolts on the antenna unit with anticorrosive sealant (supplied).

Ground terminal

	Hex bolt
			Flat washer
Ground wire			Flat washer
			Spring washer
			Hex nut
Coat with	OR
anticorrosive
sealant.
Ground wire		Hex nut
			pring washer
		S
			Flat washer
			Hex bolt

Welding

Arrange ground terminal as close as possible to antenna unit.

Seal washer

Corrosion- proof rubber mat

Use two nuts. (Torque: 63.5 Nm)

Lay corrosion-proof rubber mat, bolt antenna unit to mounting location, and coat exposed hardware with anticorrosive sealant.

Fasten ground wire and then coat with anitcorrosive sealant.

Ground wire

Antenna chassis

Ground terminal provided on antenna base.

Mounting the antenna unit

1-6