Furuno FAR-2157-D, FAR-2157-BB Flush mounting, Contents of flush mount kit for RCU-014/015/016

Flush mounting

Use the optional flush mount kit FP03-09870 (Code No. 008-535-630) to flush mount the control unit RCU-014, RCU-015 and/or RCU016 in a console.

Contents of flush mount kit for RCU-014/015/016

Name	Type	Qty
Mounting plate	03-163-7531	4
Hex bolt	M5	4
Wing screw	M5×40	4
Pan head screw	M4×12	4

1. Prepare a cutout in the mounting location as shown in the figure below.

170±2

176±2

388±2

150±2

Flush mount cutout for RCU-014 Flush mount cutout for RCU-015 and RCU-016

2.Set the control unit to the cutout.

3.From the rear side, attach the mounting plate to the control unit with four screws.

4.Screw the wing screw to each mounting plate and then insert hex bolt to each wing screw.

5.Fasten each wing screw and then fasten the hex nuts as shown in the figure below.

#70	92 (P)	#70
53
		171
	Note: P	<
		=10

53 86 (P)

# Minimum recommended service space

To change location of cable entrance, see page 1-14.

Flush mount mounting dimensions for control unit RCU-014 (left) and RCU-015/RCU-016

1-12