Furuno FAR-2157-BB, FAR-2157-D installation manual How to fabricate power cable TYPCY-2.5

8. Fabricate the power cable as shown below.

Armor

25 mm	Sheath
	5 mm
	Sheath

		FV2-4	Conductor
			S = 2.50 mm2
	500 mm
			φ = 2.01 mm
Vinyl sheath Armor
			SECTIONAL VIEW

How to fabricate power cable TYPCY-2.5

9.In the order shown in figure below, pass the gland nut, flat washers (3 pcs.) and gasket onto the power cable.

10.As shown in the figure below, fold back the armor onto flat washer (2) and insert remaining armor through flat washer (3). Cut off the part of the armor that protrudes past the flat washers

(2) and (3).

Flat washer

(1) (2) (3)

Power cable

Gland nut	Cut off armor that
	protrudes past washer.
	Gasket

Passing flat washer, etc. onto power cable

11.Pass the power cable through its cable gland and tighten gland nut. 12.Connect wiring to the terminal TB901, referring to the interconnection diagram.

CAUTION

High voltage is present at the No. 6 pin of TB901. Miswiring at this pin can damage the antenna unit.

13.Close the cover that protects pcb 03P9435.

14.Seal the cable gland for the power cable and HV cable with putty.

2-7