4.2 Memory Card Interface Unit
Mounting considerations
When selecting a mounting location, observe the following points:
•Locate the unit away from heat sources because of heat that can build up inside the cabinet.
•Locate the unit away from places subject to water splash and rain.
•Leave sufficient space at the sides and rear of the unit to facilitate maintenance.
•A magnetic compass will be affected if the unit is placed too close to the magnetic compass. Observe the compass safe distances on page ii to prevent interference to a magnetic compass.
Mounting procedure
Flush mounting
This unit can be
1.Prepare a cutout in the mounting location, referring to the outline drawing at the end of this manual.
2.Screw in the threaded rods to the flange on the front panel of the unit securely by hands.
3.Set the unit to the cutout.
4.Insert the flat washer, spring washer and nut in that order for each rod and fasten the nuts.