Furuno 1932, 1942, 1832 manual ARP-10, Not used, Make sure the follows on Self Test menu

4.On the "TCPA Set" line, select a TCPA limit desired. (30s, 1, 2, 3, 4, 5, 6, 12M)

5.Press the [ACQ/ENTER] key.

6.Press the [MENU] key to close the menu.

The flashing of the triangle plot symbol and vector remain on the screen until the danger- ous situation is no longer present or you in- tentionally terminate tracking of the target by using the [SELECT/CANCEL] key.

Lost Target Alarm

When the system detects a loss of a tracked target, the target symbol becomes a flashing diamond.

Installation of ARP-10

Necessary Parts

ARP-10 (000-086-852)

Name	Type	Code No.	Qty
ARP-10 Board	18P9007	008-476-930	1
Spacer	SQ-20	000-801-650	3
Spring Washer	M3 C5191W	000-864-204	3
**	M3x8 C2700W	000-881-404	3
Pan Head Screw
			5
Pan Head Screw	3x8 SWRM10	000-805-774	3
(w/washer) *

* Not used.

**:Use three screws only.

Mounting (For technician only)

1. Remove the cover from the display unit as follows.

1 Unscrew four binding screws (M4 x

10).

2 Unfasten six binding screws (M3 x

10).

3 Remove three rubber covers to loosen three hex nuts.

4 Loosen two hex nuts.

11

2

2

4

AP-8 1 3 1

2.Attach the ARP-10 Board to the right-hand chassis of the display unit, using the spacer supplied as follows.

1)Fasten three spacers tightly.

2)Attach the P107 connector on ARP- 10 Board to J107 connector on SPU Board.

3)Tighten three pan head screws to fix the ARP-10 Board.

Front

Spring Washer $

M3 3pcs.

Spacer

SQ-20 3pcs.

$

Pan Head

Screw

M3 x 8 3pcs.

P107

J107

ARP-10 Board	SPU Board
18P9007	03P9369

$: Pull the front panel slightly to fix these screws.

Input Signal Check

Place the radar in transmit condition after con- necting the speed and heading sensor. Make sure the following items are OK on Self Test menu.

•SPEED

•COURSE

•TRIGGER

Video Signal Check

Make sure the follows on Self Test menu.

•VIDEO : OK

•Adjust GAIN, A/C SEA and A/C RAIN so that the readout for FE-DATA 1 and 2 are less than 1,000.