Priority Valve Kit (79691A1) Information
This kit information (in ªInstallation Instructionº form) is provided to assist personnel when servicing dual installations where both engines are equipped with power steering pumps, coolers, related hardware and hoses, and one transom assembly is equipped with power steering.
Although the system may already be installed, refer to appropriate sections and follow instructions that relate to your task when servicing those components.
NOTE: A system flow diagram is located on the last page of this section.
Installing Reservoir
1.Mount reservoir bracket.
a.Find a location between both power steering pumps that affords both accessibility and easy visual inspection of fluid level. Location must be at least 6 in. (152 mm) higher than pump cap to allow fluid from reservoir to flow freely to pumps (preferably on transom or on forward engine compartment wall).
Index
b.Install reservoir mounting bracket with hard- ware supplied.
a
71402
a - measurement - 6 Inch (152 mm) Minimum
2.Position bottle reservoir in mounting bracket and secure with retainer spring.
a
b
c
e
d
72854
a - Reservoir Bracket
b- Reservoir Spring Retainer Tab
c- Screw and Washer (Not Shown In This View)
d- Reservoir Bottle
e- Retainer Spring